Air initially at a dry-bulb temperature of 45 degrees c and

Assignment Help Mechanical Engineering
Reference no: EM13612291

Air initially at a dry-bulb temperature of 45 degrees (C) and hr = 10% is adiabatically humidified to hr = 60%.

(a) determine the adiabatic saturation temperature from the psychrometric chart.
(b) determine the final temperature and the rate of water addition to humidify 15 kg/min of the initial air.

Reference no: EM13612291

Questions Cloud

In the manufacture of 10000 units of a product direct : in the manufacture of 10000 units of a product direct materials cost incurred was 145800 direct labor cost incurred was
There is a magnetic field of magnitude b directed : consider a straight piece of copper wire of length 8 m and diameter 4.5 mm that carries a current i 7 a. there is a
2642 galmin of 100 sulfuric acid at 25 degrees c is mixed : 26.42 galmin of 100 sulfuric acid at 25 degrees c is mixed with 44.49 galmin of liquid water at 15 degrees c. if the
A not-for profit nursing home has total expenses of 20 : a not-for profit nursing home has total expenses of 20 million. sales tax in the state is 7. expenses are broken down
Air initially at a dry-bulb temperature of 45 degrees c and : air initially at a dry-bulb temperature of 45 degrees c and hr 10 is adiabatically humidified to hr 60.a determine
If the hoop is 305 m above the ground by what horizontal : i shoot a basketball at an angle of 65.0 degrees above the horizontal from a height of 2.00 m above the floor. the ball
Flip earns a salary of 7500 per month during the year fica : flip earns a salary of 7500 per month during the year. fica taxes are 8 on the first 100000 of gross earnings. federal
A stream of methanol vapor is used to chill a : a stream of methanol vapor is used to chill a countercurrently flowing saturated steam in an adiabatic heat exchanger.
Four point charges of magnitude 2microc are at the corners : four point charges of magnitude 2microc are at the corners of a square with sides 4m. if this configuration was

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A helical spring of stiffness k is cut into two halves and

mechanical vibrations a helical spring of stiffness k is cut into two halves and a mass m is connected to be 0.5 s. if

  If solar radiation is incident on the spacecraft at a rate

would a flagpole made of steel or aluminum freeze ones tongue to it faster? why? thermal conductivity 2. the outer

  Why are tangent points so important when sketching

why are tangent points so important when sketching, drawing on paper with instruments, or using cad?

  Heat is now transferred to the refrigerant and the piston

a piston-cylinder device initially contains 1.4 kg of refrigent-134a at 140 kpa and 20 degc. heat is now transferred to

  The end of the lever arm moves 50cm and the load moves 20cm

in a system a lever needs and effort of 200n to lift a load of 350n. the end of the lever arm moves 50cm and the load

  The slotted link is pinned at o and as a result of the

the slotted link is pinned at o and as a result of the constant angular velocity theta dot 3rads it drives the peg p

  Determine the net electric output

Water enters a hydraulic turbine through a 30-cm-dia pipe. The pressure drop in the turbine is measured by a mercury manometer to be 1.2 m. For a combined turbine-generator efficiency of 83%, determine the net electric output. Disregard the effect..

  Explain what is the tangential force

A spur gear has 48 teeth with a diametral pitch of 8 and a pressure angle of 20 deg. The face width is 0.75 inches. If the gear is transmitting 25 HP at 250 rpm

  The power output of the turbine is 25 mw neglecting changes

steam enters an adiabatic turbine steadily at 8 mpa and 500 c through an inlet with cross-section area of 0.041767 m2

  Find the desired radius and mass of the absorber

Find the desired radius and mass of the absorber if the absorber is to not exceed an angular deflection amplitude of 30 degrees when the engine is running at 750 rpm.

  Find the cartesian components of force p acting in the x y

find the cartesian components of force p acting in the x y and z directions given p20n alpha 134.5 deg beta 55.0 deg

  What is the pressure in the tank

If 300 Kg of air is pumped into a previously empty 100 m^3 tank, and the temperature of the air in the tank is 25 deg C, then what is the pressure in the tank in N/m^2?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd