Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Modified Brayton cycle is to be analyzed using the air-standard assumption with constant specific heats at a temperature of 300K. Air flows through the Brayton cycle with a mass flow rate of 400 kg/s and enters the first compressor with a pressure of 100kPa and a density of 1.2 kg/m3.
It is then compressed to 800kPa in the first of two compressors with an isentropic efficiency of 85%. After this compression, the air is cooled at constant pressure where it is now found to have a volumetric flow rate of 57.4 m3/s when it enters the second compressor. The second compressor has an isentropic efficiency of 85% as well and the air leaves this stage of the cycle at a pressure of 2.5 MPa.The cycle has a regenerator with an effectiveness of 75% which heats the air to a temperature of 600K after leaving the final compressor. The air enters the first turbine which has an isentropic efficiency of 90% at a temperature of 1200K after which it expands to a pressure of 700 kPa. The second and last turbine stage has an isentropic efficiency of 80%.
Determine:
a) Sketch the cycle on a T-S diagram and clearly label all your statesb) The temperature of the air leaving the last turbinec) The net power production of the cycled) The thermal efficiency of the cycle
What is the concentration of FeCl3 in a solution prepared by dissolving 20.0 g of FeCl3 in enough water to make 275 mL of solution?
what is the pressure difference over the manometer in newtons per meter?
jet-type pumps are sometimes used for special purposes such as to circulate the flow in basins in which fish are being
a small sphere of reference-grade iron with a specific heat of 447 jkgk and a mass of 0.515 kg is suddenly immersed in
consider a steam power plant with reheat that operates on a modified rankine cycle. steam enters the high-pressure
the tie rod ab and a pipe strut ac are used to support a 100-kn load as shown in the figure. both members are made of
if a mass of cobalt is replaced by a compound with a density of 4.13 mgm3 and results in a mass reduction of 0.79 kg
The temperature of the water drops to 260 F as a result of heat transfer to the surroundings. Determine the final pressure in the tank?
As shown, a 150 lb bungee jumper wants to jump from the top of a 630 ft high bridge and be able to just touch the water below. Given that the bungee cord has a spring constant of 108 lb/ft, what should the bungee cord's relaxed length, l, be for t..
a timber beam is to be selected to sustain a maximum transverse shear of vmax 50 kn without exceeding an allowable
an evacuated 150-l tank is connected to a line flowing air at room temperature 25 degree c and 8 mpa pressure. the
the rigid bar is orginally horizonal and is supported by two cables each having a cross-sectional area of 0.05in2 and
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd