Reference no: EM132392920

Advanced Flow Modelling Assignment -

Procedure and discussion points:

1. Create the computational geometry in DesignModeler/ Solidwroks/any CAD software with the mentioned dimensions.

2. Build an appropriate mesh for the model and perform a grid refinement study.

3. Using the converged grid, check the iterative convergence.

4. Draw the Velocity contour at different selected planes of your model and discuss your results.

5. Draw the pressure contour at different selected planes of your model and discuss your results.

6. Plot the temperature profile along a selected line from inlet to outlet and discuss.

7. Draw the wall shear stress and discuss.

8. Plot the axial velocity profile at any selected position of your model and discuss.

9. Draw the Velocity vectors at different selected planes of your model and discuss your results.

10. Calculate the drag and lift coefficient and discuss (if applicable).

11. Calculate the deposition efficiency/deposition fraction and discuss (if applicable).

12. Draw the particle trajectories for different flow rates and discuss (if applicable).

13. Calculate the heat transfer coefficients (if applicable).

14. Calculate the Nusselt number from the following correlation and discuss (if applicable);

Nu_D = 0.023Re^4/5_DPrⁿ  

15. Connect your results with the existing literature.

[Deposition Efficiency = (number of injected particle/number of trapped particle)x100

Note - Find a vehicle body Drag Analysis using Computational Fluid Dynamics.

Submission: A written report is to be submitted including a short introduction and conclusion (one page long for each).