Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A typical gas stove burner supplies a kettle filled with water at a rate of 15,000 Btu/hr with a flame temperature of 750C. The gasfed to the burner is composed of propane mixed with 10% excess air. the gas feed is initially at -20C and 1 bar and the reaction proceeds to 100% completion. Determine the mass flow rate of propane in g/sec, to the stove. heat capacities - Nitrogen 29.12 J/molk, oxygen 29.32 J/mol K, propane 74.92 J/ mol K, carbon dioxide 37.14 J/mol k, and water 33.57 J/mol k
calculate the vapor pressure-temperature relationship of liquid iron.
The tank has a 180 mm inside diameter and a 12 mm wall thickness. Knowing that the tank contains compressed air under a pressure of 8 MPa, determine the magnitude T of the applied torque for which the maximum normal stress in the tank is 75 MPa.
what is an exergy factor? 8 what is a pinch point and what is it used for? 9 what does the compressor in figure 2 do?
the collar has a mass of 20kg and is supported on the smooth vertical rod. the attarched springsare undeformed when d=0.5m determine the speed of collar after the applied force F=100N causes it to be displaced so that d=0.3m when d=0.5m, the colla..
a dump truck is shown in the figure. the loaded container has a mass of 8000 kg and may be modelled as a solid
unidirectional reinforced composites1. calculating the mechanical properties of unidirectionally reinforced composites
the maximum allowable value of each of the reactions is 180 N neglecting of the weight of beam, determine the range of te distance d for which the beam is safe.
You have a 120 Ω quarter bridge 2 wire set up with Sg=2.10 and an unknown lead wire resistance. A 59880Ω calibration resistor is switched in parallel to the gage only and a recording instrument is set to give a -100 mm deflection for this calibrat..
plot your results determined in the previous part. (c) Calculate the values of n and C in the Taylor equation solving simultaneous equations.
What will the ratio of the angle of twist be to that of the hollow shaft if the maximum shear stress in the material of 75 N / mm ^2 and what is the ratio of actual permissible shear stress?
A magnetic pickup is used to detect the shaft speed of a turbocharger. A standard hexagonal nut is used to excite the pickup. If the shaft is turning at 50,000 rpm, how many positive impulses will be counted per second?
determine the design stress for bolts in a cylinder cover where the load is fluctuating due to gasnbsppressure. the
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd