A pneumatic lift system is being demonstrated at a sales

Assignment Help Mechanical Engineering
Reference no: EM13627080

A pneumatic lift system is being demonstrated at a sales show. The total load is 70 kg, and the lift piston is 15.2 cm in diameter and has a 20.2 cm stroke. A portable air bottle with an initial pressure of 20 MPa and a temperature of 23 Celsius degrees is to be used as the pneumatic supply. A regulator reduces the pressure from the bottle to the lift system. Neglecting all volume in the lines from the bottle to the piston, determine the number of times the piston can operate per air bottle if the air in the bottle remains at 23 celsius degrees and the volume of the bottle is 0.05 m3

Reference no: EM13627080

Questions Cloud

Find how many positive integers with exactly four decimal : find how many positive integers with exactly four decimal digits that is positive integers between 1000 and 9999
Steam at 200 c and 7 bars enters a mixing tank at a rate of : steam at 200 c and 7 bars enters a mixing tank at a rate of 3 kgmin through a pipe with a cross-section of 1.20 cm2.
Ten kilograms of ice at 260 k is dumped into 20 kg of : ten kilograms of ice at 260 k is dumped into 20 kg of liquid water initially at 300 k in an insulated container. the
Consider writing onto a computer disk and then sending it : consider writing onto a computer disk and then sending it through a certifier that counts the number of missing pulses.
A pneumatic lift system is being demonstrated at a sales : a pneumatic lift system is being demonstrated at a sales show. the total load is 70 kg and the lift piston is 15.2 cm
An ideal gas with molecular weight of 65 kgkgmol is : an ideal gas with molecular weight of 6.5 kgkgmol is compressed in a reversible manner from 690 kpa and 277 k to a
What is the temperature in kelvin assuming an adiabatic : an oil well is drilled in the atlantic ocean where the water depth is 350 meters.a suppose methane gas forms a bubble
A simple harmonic oscillator has a mass m0 on a spring of : a simple harmonic oscillator has a mass m0 on a spring of force constant k. the system is damped. it takes 10 cycles
The wires carry current in opposite directions if the : two wires parallel to each other and seperated by a distance d carry different currents they exert a force with

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Pumps and heat recovery

Energy in the home, personal energy use and home energy efficiency. Efficient use of ‘waste' heat and renewable heat sources.

  Determine the maximum sustainable torque that the tubular

a solid circular shaft and a tubular shaft both with the same outer radius of cc0 0.600 are being considered for a

  What is the pressure in the tank

If 300 Kg of air is pumped into a previously empty 100 m^3 tank, and the temperature of the air in the tank is 25 deg C, then what is the pressure in the tank in N/m^2?

  Five 100 ohm resistors each having 5 tolerance are

five 100 ohm resistors each having 5 tolerance are connected in series. what is the overall nominal resistance and

  If the probe surface has an emissivity of 08 and it does

a spherical interplanetary probe of 0.5-m diameter contains electronics that dissipate 150 w. if the probe surface

  Find the desired radius and mass of the absorber

Find the desired radius and mass of the absorber if the absorber is to not exceed an angular deflection amplitude of 30 degrees when the engine is running at 750 rpm.

  What is the flow rate m3 of the gasoline and kerosene

crude oil is fractioned by two separating columns. the incoming crude oil is composed of the following weight fractions

  The launch vehicle takes the moon orbiter to a circular

the launch vehicle takes the moon orbiter to a circular orbit around the earth at 300km altitude. the orbiter is to

  Determine the no2 emissions rate lbhr from a steam plant

determine the no2 emissions rate lbhr from a steam plant that uses sugar mill waste 3300 btulb to generate 1000 lb

  Air enters a compressor at 14 psia 80 f with negliible

air enters a compressor at 14 psia 80 f with negliible speed and is discharged at 70 psia 500 f with a speed of 500

  Determine the final temperature of the water

one part of the tank contain 2.5 kg of compressed liquid water at 60 C and 600 kPa while the other part is evacuated. the partition is now removed, and the water expands to fill the entire tank. Determine the final temperature of the water and the..

  What is the percent error in specific volume if the ideal

what is the percent error in specific volume if the ideal gas model is used to represent the behavior of superheated

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd