A heat pump with a coefficient of performance of 35

Assignment Help Mechanical Engineering
Reference no: EM13631227

A heat pump with a coefficient of performance of 3.5 provides energy at an average rate of 70,000 kJ/h to maintain a building at 20oC on a day when the outside temperature is -5oC. If electricity costs 8.5 cents per kW.h,

(a) determine the actual operating cost and the minimum theoretical operating cost, each in $/day.

(b) compare the results of part (a) with the cost of electrical-resistance heating.

Reference no: EM13631227

Questions Cloud

Air is throttled from 100 mpa and 300degc to 0100 mpa in a : air is throttled from 1.00 mpa and 30.0degc to 0.100 mpa in a steady flow adiabatic process. assuming constant specific
Calculate the fugacity and fugacity coefficient of carbon : calculate the fugacity and fugacity coefficient of carbon dioxide at 100f and 200psia from the data
A steam turbine is limited to a maximum inlet temperature : a steam turbine is limited to a maximum inlet temperature of 800.degc. the exhaust pressure is 0.0100 mpa and the
A taut rope has a mass of 0170 kg and a length of 355 m : a taut rope has a mass of 0.170 kg and a length of 3.55 m. what power must be supplied to the rope to generate
A heat pump with a coefficient of performance of 35 : a heat pump with a coefficient of performance of 3.5 provides energy at an average rate of 70000 kjh to maintain a
What is the mass of the container ignore the mass of the : a lost shipping container is found resting on the ocean floor and completely submerged. the container is 5.9 m long 2.9
Analyze a hydrogen jt cycle with isothermal compression : analyze a hydrogen jt cycle with isothermal compression occurring at 300k with an outlet pressure 2 times the
An air conditioner operating at steady state maintains a : an air conditioner operating at steady state maintains a dwelling at 20oc on a day when the outside temperature is
The wedge velocity follos the relations vx 151-100t-012 : a wedge cam has a cycloidal profile. the follower must rise 0.05m as the cam advances through 0.2m in time t0.2s.the

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  What is the suction specific speed for the pump that is

what is the suction specific speed for the pump that is operating under the conditions given in problem 14.16? is this

  Q1 15 kg of oxygen n2 and 015 kg of helium he2 are

q1. 1.5 kg of oxygen n2 and 0.15 kg of helium he2 are separated by a partition in a vessel.nbsp the nitrogen is at 5

  If the seat pocket diameter in a ball valve is 5000 the

if the seat pocket diameter in a ball valve is 5.000 the seat seal ring to ball sealing diameter is 4.438 and the

  The compressor has an isentro pi c efficiency of 95 assume

steam is expanded in an adiabatic turbine from 3 mpa and 400 c to 30 kpa. the turbine generates 4947kw of power when

  A power plant operates a regenerative rankine cycle

A power plant operates a regenerative Rankine cycle with a reheat, one closed and one open feedwater heater and has a net power output of 1.2 x 109 Btu/hr. When the steam exits the boiler it's temperature is 1000°F and its pressure is 1400psi...

  A closed gas turbine unit uses neon as the working fluid

a closed gas turbine unit uses neon as the working fluid. there are two stages of compression with intercooling from

  The plates leave a heat treatment oven 300 c and ambient

a flat steel plate is 1 m long and 1 m wide. air flows over the plate at 10 ms. the plates leave a heat treatment oven

  The flash chamber operates adiabatically and kinetic and

consider a flash chamber operating at steady state as shown in the figure below. refrigerant 134a enters the chamber at

  Assume that in orthagonal cutting the rake angle is 20

assume that in orthagonal cutting the rake angle is 20 degrees and the friction angle is 35 degrees at the chip-tool

  What exposure time is necessary for the concentration of

although ripening of tomatoes can be retarded by low temperatures storage under refrigeration can cause chilling injury

  Find the mass flow rate of the air through the handler m

consider an ideal vapor-compression air conditioner with a cooling capacity of q dotc 4 tons whose evaporator is used

  What is the maximum range that this vehicle can have

some engineers have suggested that air compressed into tanks can be used to propel personal transportation vehicles.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd