### A gage pressure of 400 kpa acting on a 4-cm diameter

Assignment Help Mechanical Engineering
##### Reference no: EM13631841

A gage pressure of 400 kPa acting on a 4-cm diameter piston is resisted by an 800-N/m spring. How much is the spring compressed? Neglect the weight of the spring.

### Write a Review

#### A worm gear set has a velocity ratio of 005 the worm has

a worm gear set has a velocity ratio of 0.05. the worm has two teeth a lead of 3 in. and a pitch diameter of 1.5in.

#### A power plant based on the rankine cycle is under

a power plant based on the rankine cycle is under development to provide a net power output of 10 mw. solar collectors

#### What assumptions is are made for the situation of applying

in order to compute strains in a composite layer that is one layer consisting of a matrix materials and fibers parallel

#### Find densities, enthalpies and efficiency for gas

find densities, enthalpies and efficiency for gas turbine power cycle with the following conditions.

#### Blocks d and f weigh 50 lb each and block e weighs 80 lb

blocks d and f weigh 50 lb each and block e weighs 80 lb. determine the length s for equilibrium. neglect the size of

#### Determine the maximum thermal efficiency for any power

ocean temperature energy conversion otec power plants generate power by utilizing the naturally occurring decrease with

#### The surfaces air temperature is 15 degree c a parcel of air

the atmosphere is stable with a lapse rate of -0.2 degree c100 m. the surfaces air temperature is 15 degree c. a parcel

#### The temperature surrounding the dmm is 30 degrees c the

a type e thermocouple is placed in an oven and connected to a dmm. the temperature surrounding the dmm is 30 degrees

#### Determine the pressure, temperature and enthalpy at entrance

A heat pump uses refrigerant-134a as the working fluid in an ideal vapour-compression refrigeration cycle between 0.14 and 0.8 MPa. The refrigerant leaves the compressor at a temperature of 40° C. Determine the pressure, temperature and enthalpy a..

#### At the nozzle exit the pressure is 147lbfin2 and the

steam enters a well insulated nozzle operating at steady state at 1000?f and 500lbfin2 and velocity 10fts. at the

#### Determine the tension in the cable when the balloon is

a balloon uses hot air to provide its lifting capacity. prior to its release it is tethered to the ground by a steel

#### What is the indentation diagonal length when a load of 075

what is the indentation diagonal length when a load of 0.75 kg produces a vickers hv of 510? calculate the vickers