A double pipe heat exchanger serves as an oil cooler with

Assignment Help Mechanical Engineering
Reference no: EM13630798

A double pipe heat exchanger serves as an oil cooler with oil flowing in one direction through the inner tube and cooling water in the opposite direction through the annulus. The oil flow rate is 0.63 kg/s, the oil has a specific heat of 1.68 kJ/kgK, the water flow rate is 0.5 kg/s, and its specific heat is 4.19 kJ/kgK. In a test of a prototype, oil entering at 78°C was cooled to 54°C when the entering water temperature was 30°C.The possibility of increasing the area of the heat exchanger by increasing the length of the double pipe is to be considered. If the flow rates, fluid properties, and entering temperatures remained unchanged, what will be the expected outlet temperature of the oil be if the area is increased by 20 percent?

Reference no: EM13630798

Questions Cloud

A mixture of methanol and methyl acetate contais 150wt : a mixture of methanol and methyl acetate contais 15.0wt methanola. using a single dimensional equation determine the
Now suppose that the road is dry and that the static : as you are riding in a 1650-kg car you approach a hairpin curve inthe road whose radius is 50m. the roadbed is banked
Warm air is contained in a piston-and-cylinder device : warm air is contained in a piston-and-cylinder device oriented horizontally as shown below. the air cools slowly from
A weight lifter is doing a leg extension exercise in a : a weight lifter is doing a leg extension exercise in a seated position with his knee joint center of rotation fixed on
A double pipe heat exchanger serves as an oil cooler with : a double pipe heat exchanger serves as an oil cooler with oil flowing in one direction through the inner tube and
Find the frequency of revolution of the electron in the : find the frequency of revolution of the electron in the classical model of the hydrogen atom. in what region of the
Refrigerant 134a at a rate of 08 lbs enters a compressor : refrigerant 134a at a rate of 0.8 lbs enters a compressor operating at steady state as saturated vapor at 30 psia and
Find the quantum number that characterizes the earths orbit : find the quantum number that characterizes the earths orbit around the sun. the earth mass is 6.0x1024 kg its orbital
The reservoir pressure and temperature for a blowdown : the reservoir pressure and temperature for a blowdown supersonic wind tunnel are 7.5 atm and 800 deg r respectively.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  In a brinell hardness test a 1500-kg load is pressed into a

in a brinell hardness test a 1500-kg load is pressed into a specimen using a 10-mm diameter hardened steel ball. the

  The coefficient of friction of the metal against the dies

a cylinder of metal that is originally 100mm tall and 50mm in diameter must be open die forged to a height if 50mm. the

  If the max allowed normal acceleration is equal to 2g where

a race boat is traveling at a constant speed v0 77mph when it performs a turn with a constant radius rho to change its

  Determine the greatest allowable steam pressure

the moisture content at the turbine exhaust is not to exceed 15%. determine the greatest allowable steam pressure at the turbine inlet and calculate the cycle efficiency.

  A turbine produces 2 mw of power while accepting steam at 3

a turbine produces 2 mw of power while accepting steam at 3 mpa and 400 c and rejecting steam at 50 kpa and 100c. find

  Two tanks tank a and tank b are seperated by a partion

two tanks tank a and tank b are seperated by a partion. initially tank a contains 2 kg steam at 1mpa and 300 celsius

  The pressure in the piston and the pressure in the balloon

the piston diameter is dp 3 mm and the piston position is initially s1 5 cm from the bottom of the piston. at this

  Calculate the static thrust of the turbojet engine

Calculate the static thrust of the turbojet engine having mass flow 88lbm/sec the ratio of air and fuel mass flowing into the turbojet is 50:1 and it's exhaust plane the velocity is 1640 ft/sec and pressure is same as ambient pressure?

  What is the total energy released by burning the mass of

over a period of time a car engine burns 0.01kg of fuel equivalent to supply of qh from a high temperature reservoir at

  What is the change of internal energy and enthalpy of 4 kg

what is the change of internal energy and enthalpy of 4 kg nitrogen as it changes from 50oc and 100kpa to 100oc and

  The system is heated until the temperature reaches 100degc

a steel bolt is placed through an aluminum tube. sturdy washers are placed on each end of the tube and the bolt is

  What is the velocity and rate of flow of the metal

What is the velocity and rate of flow of the metal into the mold? Is the flow turbulent or laminar? (Pure aluminum density ρ = 2.7 g/cm3).

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd