Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A computer will be used to control flow through 10 pumping stations. The pumps exhibit a surging effect with a period of 2.2 sec. What is the minimum sampling rate to ensure quality data? How much time can be spent processing each station's data? Data acquisition hardware and software take 200µ sec for a channel.
In US, electric wires are classified based on their gauge numbers. The larger the gauge number is, the smaller the diameter of the cross-section of the wire becomes. You are given four different types of wire with gauge numbers 1, 3, 7, and 8.
The doping level of N-type semiconductor is Nd= 5^19 cm^-3. Determine the room tempature position of the Fermi level ( with respect to the bottom of the comduction band) if the semiconductor is A). Si (Nc=2.86^19cm^-3)
if we have an amplifier whose spec. is 2nV/rtHz and the bandwidth of the amplifier extends from 100Hz to 10kHz, and the gain of the amplifier is 5, how much noise should we expect at the output of the amplifier
Design a circuit that outputs 0 volts when the input is above2.5volts, and outputs 5 volts when the input is below 2.5 volts.You may use power supply voltages of +10V, 0V and -10V. Be sureyour circuit will drive a low resistance load.
The difference in voltage (Bat A - Bat B) should be displayed on a +5V - 0 -5V meter. Each volt on the meter display should correspond to 10 mV of battery difference. Include your choice for all components and power supply voltages.
For example, if the time given is 10213 seconds, the function will give back 2 hours and 50.22 minutes. The function shall not print the results to console, but instead pass them back to the calling function.
A three phasestar connected alternator with synchronous impedance of 1+j5 ohms per phase is connected to an 11kV system. The alternator power outputis found to be 10MW and reactive power output as 3MVAr.
Charge +Q is distributed evenly throughout a 1m length of the innerconductor, and a charge -Q is evenly distributed throughout a 1mlength of the outer conductor, find equations for the electric fluxdensity for all p.
A coax cable has an inducance of 300nH/m and capacitance 53pF/m and carries very high frequency radio waves. Sart with the quantity gamma for transmission line, explain your approximations and find the phase velociy of propagation.
A 85F capacitor is charged by a constant current source, and its voltage is increased to 6 V in 7 s. Find the value of the constant current source, Is, and the energy stored in the capacitor after 7 s.
The design must show all stages used in its development and must be implemented and tested in PSpice and suitable timing waveforms produced.
To digitally manipulate information we must encode it using binary numbers. Consider an encoding for playing cards. There are 52 cards in a deck and they are divided
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd