A certain superinsulation material having a thermal

Assignment Help Mechanical Engineering
Reference no: EM13625870

A certain superinsulation material having a thermal conductivity of 2 x 10^-4 W/m.C is used to isulate a tank of liquid nitrogen that is maintained at -196 degrees celcius; 199 kj is required to vaporize each kilogram mass of nitrogen at this temperature. Assuming that the tank is sphere having an inner diameter(ID) of 0.56 m, estimate the amount of nitrogen vaporized per day for an insulation thickness of 2.5 cm and an ambient temperature of 25 degrees celcius. Assume that the outer temperature of the insulation is 25 degrees celcius.

Reference no: EM13625870

Questions Cloud

A person reading a european newspaper finds that the low : a person reading a european newspaper finds that the low temperature the night before in stockholm was -16 degree
An unstable particle is created in the upper atmosphere : an unstable particle is created in the upper atmosphere from a cosmic ray and travels straight down toward the surface
The density of seawater can be taken to be 1025 kgm3 and : the ocean thermal energy conversion otec power plant takes advantage of the temperature difference between ocean
A 500 g steel rod 30 cm in length is pivoted about its : a 500 g steel rod 30 cm in length is pivoted about its center and rotated at 300 rpm.a what is the angular momentum?b
A certain superinsulation material having a thermal : a certain superinsulation material having a thermal conductivity of 2 x 10-4 wm.c is used to isulate a tank of liquid
Suppose that an insurance agent offers you a policy that : suppose that an insurance agent offers you a policy that will provide you with a yearly income of 50000 in 30 years.
Aforce of 12000 lbf was required for rock failure and the : a rock sample is placed in a strength-testing machine at atmospheric pressure and compressed axially to failure. a
Defects in computer hard-drives will usually render the : defects in computer hard-drives will usually render the entire computer worthless. for a particular model the percent
What distance as measured in the laboratory does the pion : the negative pion is an unstable particle with an average lifetime of 3.30 times10-8 s measured in the rest frame of

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A stone of 20 kg of mass is held 15 m above a tank

a stone of 20 kg of mass is held 15 m above a tank containing 200 kg of water. the stone water and the air are at the

  Find a transfer function between armature voltage and

a loudspeaker is modeled with the following three equations.mx bx blittecoil blxldidt ri va - blxfind a transfer

  Determine the power required by the compressor and the rate

air with mass flow rate of 0.4 kgs enters an insulated compressor operating at steady state.determine the power

  How long should the roughing section be what pull must the

a roughing section of a broach is to remove stock 3.2 mm deep from a steel surface205 mm long x 50 mm wide each tooth

  Determine the heat transferred and the work done both in

determine the heat transferred and the work done both in kjkg when saturated water vapor in a closed system is

  A keg of beer loumlwenbraumlu sg 111 has a small pinhole

a keg of beer loumlwenbraumlu sg 1.11 has a small pinhole leak in it. the beer sprays vertically into the air to a

  What are the forces on the pinion gear and shafts

What are the forces on the pinion,gear,and shafts?

  Evaluate the reduction in pump bhp

Evaluate the reduction in pump BHP required by heating the oil from 50° F to 100° F. Suppose efficiency of 80% (HP)

  Increasing volume of balloon problem

A spherical balloon inflated sos that the volume is increasing at the rate of cubic meter/min. At what rate is the diameter increasing when the diameter is 12 m?

  Determine changes in composition of a fluid

What information has to be obtained in order to ensure that the method will be a satisfactory one and determine changes in composition of a fluid. Define what is meant by refractive index, and give the relationship between the incident and refracte..

  If the data set was split into 5 sets 4 s long each what is

an accelerometer was used to measure the vibrations of machinery. the sensor output was acquired during an experiment

  Draw free body diagram - shear and moment diagrams

Determine if the shaft has infinite fatigue life. If not, determine the number of cycles to failure. Also determine the safety factor for first cycle yield and draw a free body diagram, shear and moment diagrams, and graph the loads on the shaft..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd