User Account

All Pages

100 lb of fluid food is heated by addition of 10000 btu of

Assignment Help Mechanical Engineering
Reference no: EM13610559

100 lb of fluid food is heated by addition of 10,000 Btu of energy. If the food has initial temperature of 40°F, and Cp=0.9 Btu/lb-°F, what is the temperature when it is done heating?

Reference no: EM13610559

Questions Cloud

The collector transfers heat by natural convection to the : a flat plate solar collector 6 ft by 12 ft is mounted on the roof of a house. the outer surface of the collector is at
Determine the change in the internal energy of the system : nitrogen at 100c and 600 kpa expands in such a way that it can be approximated by a polytropic process with n 1.2.
Kendrick corporation was organized on january 2 2011 during : kendrick corporation was organized on january 2 2011. during 2011 kendrick issued 20000 shares at 24 per share
Michelangelo inc a software development firm has stock : michelangelo inc. a software development firm has stock outstanding as follows 25000 shares of cumulative 4 preferred
100 lb of fluid food is heated by addition of 10000 btu of : 100 lb of fluid food is heated by addition of 10000 btu of energy. if the food has initial temperature of 40degf and
The alpenrose milk company uses a perpetual inventory : the alpenrose milk company uses a perpetual inventory system. the following transactions affected its merchandise
It is agreed that the land is to be priced at 200000 and : fantastic sounds corp. an electric guitar retailer was organized by pam mikhail jane lo and dale nadal. the charter
An entomologist writes an article in a scientific journal : an entomologist writes an article in a scientific journal which claims that fewer than 20 in ten thousand male
Dorantes manufacturing company uses a standard cost system : dorantes manufacturing company uses a standard cost system. in 2010 28000 units were produced. each unit took several

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A exit p2 - 147 psia v2 2677 ft3lb and u2 10775 btulb

there are supplied to a nozzle 2400 lbhr of steam at an absolute pressure of 200 psia. at the entrance v1 6000 ftmin

  Compute the atomic packing factor

The unit cell for uranium has orthorhombic symmetry with a, b and c lattice parameters of 0.286, 0.587, 0.495 nm, respectively. If its density, atomic weight, and atomic radius are 19.05 g/cm3, 238.03 g/mol, and 0.1385 nm, respectively, compute th..

  Find max specific range and max range airspeed

Find Max Level Airspeed at 95% RPM and find Max Range Airspeed (VBR) and Max Endurance Airspeed (VBE) - find Max Specific Range and Max Range Airspeed

  Determine the particles velocity and acceleration vectors

a particle a is pulled horizontally by a scotch-yoke with a constant velocity v along the elliptical slot given by the

  What is the air temperature at the stagnation point

A high performance F-16 fighter is flying at Mach 0.96 at sea level. What is the air temperature at the stagnation point at the leading edge of the wing?

  What time will be required at 500degc to produce the same

the wear resistance of a steel shaft is to be improved by nitrogen hardening of its surface. the initial nitrogen

  A flywheel can be considered as being composed of a thin

a flywheel can be considered as being composed of a thin disc and a rim. the rim weighs 322 lb and has diameters of 24

  Determine the tension t in the cable

System of force and cable tensions is in equilibrium and what are the necessary conditions for static equilibrium and determine the area moment of inertia about Ox for the area shown under the curve

  Consider a thermal energy reservoir

Consider a thermal energy reservoir at 1500 K that can supply heat at a rate of 150,000 kJ h-1. Determine the exergy of this supplied energy, assuming an environmental temperature of 25 oC.

  Calculate the reaction force in each of supports a and b

a crate containing 40 bricks each of mass 1.3kg is placed on a storage framework as shown.a calculate the reaction

  Determine the smallest horizontal force required

Determine the smallest horizontal force required to lift the 260- crate. The coefficient of static friction at all contacting surfaces is = 0.7. Neglect the mass of the wedge.

  Explain a car and a high speed trian at constant speeds

A car and a high -speed trian at constant speeds. three seconds after the train passes under the highway bridge the car crosses the bridge.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd