Wire drawing, Other Engineering

Wire Drawing involves pulling the metal through a die by means of tensile force applied to the exit side of the die.

         A typical wire drawing operation is shown in fig. Wire drawing die has a conical shape. The end of the wire or rod is mad into a point shape and initially it is inserted through the die opening.

         This end is then gripped by dog gripping tool and is pulled with help of chain drive. 

Posted Date: 8/3/2012 5:35:29 AM | Location : United States







Related Discussions:- Wire drawing, Assignment Help, Ask Question on Wire drawing, Get Answer, Expert's Help, Wire drawing Discussions

Write discussion on Wire drawing
Your posts are moderated
Related Questions
outline five (5) areas where thermodynamics can be applied in materials engineering

Lifting wing FP was run at the conditions corresponding to AGARD WG07 TEST CASE 11, namely M∞ = 0.84,α= 3.06 deg. The ‘final step' values of the partially-conservative paramete


Nomenclature • Information source device producing information to be communicated • Binary digit (bit) fundamental information unit for all digital systems; unit of informat

A 30m deep quarry pit is to be constructed in a jointed basalt rock mass. The quarry management wants to maximise the side wall inclination to 70° for economic reasons. The geologi

Engine fires: There are two main types of engine fire that can occur when running gas turbine engines and they are dealt with in different ways. 1. Fire in the engine nacel

an iron ring with amean dia of 50 cm has an air gap of 1mm awinding of 200 turns if the permeability of the iron is 400 when a circuit of 1.25A flows through the coil find the flux

This Compression After Impact (CAI) test fixture was developed by the Boeing Company. The specimen, typically, but not necessarily, a quasi-isotropic laminate, is 6" long, 4" wide,

Riveting  is a fixed fastening procedure in which the end of the metal pin is pressed over or spread out by hammering operation. Wrought iron and steel are used for the riveting an

Electronic APU fuel control System in Aircraft : Electronic fuel control emulates the mechanical system, however it provides control in a slightly different way. The electronic