What is control coupling, Software Engineering

Assignment Help:

Q. What is Control coupling?

Control coupling: Module A as well as B are said to be control coupled if they communicate by passing of control information. This is typically accomplished by means of flags that are set by one module and reacted upon by the dependent module.


Related Discussions:- What is control coupling

Explain iterative development model in detail, Problem 1. Explain Itera...

Problem 1. Explain Iterative Development Model in detail 2. Explain the Incremental Development Model in detail 3. What are the major technical and non-technical factors whic

Discuss in details the design steps in transaction mapping, Discuss in deta...

Discuss in details the design steps in transaction mapping. Re-Check the fundamental model. Re-check and refine the DFD for the software. Determine the DFD has either

Performing validation testing, What are the conditions exists after perform...

What are the conditions exists after performing validation testing? After performing the validation testing there exists two conditions.  The function or performance charact

Define quality control, Explain Quality control This includes checking ...

Explain Quality control This includes checking the software development process to make sure that procedures and standards are being followed. There are two approaches to qu

What are the profits of vertical partitioning, What are the profits of vert...

What are the profits of vertical partitioning? i. These are very easy to maintain changes. ii. They decreased the change impact and error propagation.

Show reasons why it is difficult to improve software process, Q. List four ...

Q. List four reasons why it is difficult to improve software process. Ans It is difficult to get better software process due to following reasons: 1. Lack of knowledge-

State the level 5 of key process areas, Level 5 KPAs 1)Defect Prevent...

Level 5 KPAs 1)Defect Prevention (DP): It discovers causes of defects and devises techniques which prevent them from recurring. 2)Technology Change Management (TCM): It

Managing variability, 1.    McM Cog is a supplier of industrial parts.  Mos...

1.    McM Cog is a supplier of industrial parts.  Most orders are received at a call center. The call center currently has 10 phone lines total, i.e., a maximum of 10 callers may b

Explain basic execution time model, Q. Explain Basic Execution Time Model? ...

Q. Explain Basic Execution Time Model? The model was developed by the J.D. MUSA in 1979(MUSA79) and is based on execution time. It is presumed that failures may occur according

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd