Use of trusses, Mechanical Engineering

Use of trusses:

Where do you find trusses in use?

The main uses of truss are as follows:

1. The trusses are used to support slopping roofs.

2. Brick trusses are taken in bridges to support deck etc. Analysis of the frame comprises of,

(a)  By determinations of the reactions at supports.

(b)  By determination of the forces in members of the frame.

Posted Date: 10/20/2012 2:23:10 AM | Location : United States







Related Discussions:- Use of trusses, Assignment Help, Ask Question on Use of trusses, Get Answer, Expert's Help, Use of trusses Discussions

Write discussion on Use of trusses
Your posts are moderated
Related Questions
Engine Oil Replacement and Top-up :   The engine oil has to be changed at a periodic interval because after some point of time it loses its viscosity and cooling, anti rust, and se

Dry Saturated Steam - thermodynamics: A dry saturated steam is single phase medium. It does not have any water particle. It can be obtained on complete evaporation of water at

(a) Oil, with density ρ= 900 kg/m 3 , and kinematic viscosity υ=0.00001m 2 /s, flows at the rate of 0.2m 3 /s through 500m of a cast iron pipe of diameter d=200mm. Using this infor

Illustrate the various Functions of clutch and also explain the Principle of frictions Clutch ? What is the requirement of Transmission System & Explain the Arrangemnet for P


Reassembly Position of Critical Parts:  Care should be taken to note the position of the unidirectional parts while dismantling the engine. This will ensure dimensions (depth, dis

Q. Show Geographic constraints of the plant? The layout of process units will be influenced by the geographic constraints of the site. Spacing is required between plant facilit


Determine the shape of the beam: A simply supported beam of span l carries a concentrated load P at midspan. If the beam is to be a beam of consistent strength, determine the

The Radial Dimension Commands There are 2 main radial dimension commands, DIMDIAMETER & DIMRADIUS. Both commands result in  similar looking dimension so AutoCAD automatically i