Manufacturing process, Mechanical Engineering


Deferentiate between hot working and cold working processes
Posted Date: 7/22/2013 8:00:52 PM | Location : USA







Related Discussions:- Manufacturing process, Assignment Help, Ask Question on Manufacturing process, Get Answer, Expert's Help, Manufacturing process Discussions

Write discussion on Manufacturing process
Your posts are moderated
Related Questions
use of productin drawing in manufacturing technolagy

derivation for varing shear stress for thin circular tubes.

Work done - thermodynamics: A free expansion process is a process in which system expands freely without experience any resistance. I.E. is constant at the time of state chang

How is local shear mode characterized in bearing capacity? Local Shear Failure The local shear mode of failure is characterized by slip zones, small surface heave and a poor


A competitor in a hill-climb event finds during practice that his car becomes airborne at a particular point on the hill.  Shortly after landing the lowest point in the car just co

Can you Differentiate between : Dynamometer and Brakes. Absorption Dynamometer and Transmission Dynamometer.

#question.want settle down where sheet metal engineers are required.

Figure shows a reinforced concrete framed building subjected to earthquake ground motion. The floor is rigid with the mass of each floor is shown in the figure. Formulate the equat

Valve Clearance and Tappet Adjustment: Like all metal components the valve expands on heating. Hence the valve clearance is set so that on expansion there is room for the valve to