Steam turbine types, Mechanical Engineering

Is bleed necessary in condensing and back pressure both the turbine?
What is the use of bleed in steam turbine?
What is the basic difference in condensing and backpressure turbine in applicationwise?
Posted Date: 3/21/2013 4:31:56 AM | Location : USA







Related Discussions:- Steam turbine types, Assignment Help, Ask Question on Steam turbine types, Get Answer, Expert's Help, Steam turbine types Discussions

Write discussion on Steam turbine types
Your posts are moderated
Related Questions
Diesel (Constant Pressure Cycle): 5-1 Suction Stroke at constant pressure 1-2 Adiabatic Compression 2-3 Heat Addition at constant pressure 3-4 Adiabatic Expan

See the Petri net represent in following figures (a) and (b) as represented in the figure for analysis and depiction of qualitative pathological behaviors. Figure: (a): An

Angular speed of the cylinder: A cylinder of mass 70 kg rotates from rest in frictionless bearing under the action of a mass of 7.0 kg carried by a rope wrapped around the cyl

A tube assembly constructed of Cu with an inside diameter of 1.25 cm, wall thickness of 0.8 mm and circumferential fins around the periphery. The fins have thickness of 3 mm, and a


Find the maximum shear stress - stepped circular bar: A stepped circular bar ABC 4 m long fixed at one of the end 'A' is subjected to a torque of 10 kN-m. If the portion AB is

Q. Maintenance requirement at storage tanks? Little maintenance is required at storage tanks; sometimes access is required for equipment used to remove accumulated solids (this

During a test on a Lister engine in a thermal laboratory, following parameters were measured; crank shaft speed=1,750rpm Load on dynamometer=220N Radius of dynamometer=1.5m Fuel co

a) Define Economics Order Quantity. Derive, using neat diagram, the mathematical formula for economic order quantity. b) The purchase manager of an industrial unit is placing on

Copper-Beryllium Alloys Copper-beryllium alloys comprise between 0.6 to 2% Be and 0.2 to 2.5% Cobalt. Such alloys can be precipitation hardened and cold worked to improve a te