Source port number - transport layer, Computer Networking

Source Port Number

This fields occupies  the first 16 bytes of the UDP header. This  fields typically hold the UDP port number  of the application sending  this datagram. The value  entered in the  source  port issued  by the receiving  application  as a return address when it  is ready to send a  response. This fields  is considered  considered  optional  and it is not required that the  sending  application  includes  is port number 

 

1336_Source Post Number.PNG

                                     figure User Datagram Protocols Format

Posted Date: 3/11/2013 5:42:26 AM | Location : United States







Related Discussions:- Source port number - transport layer, Assignment Help, Ask Question on Source port number - transport layer, Get Answer, Expert's Help, Source port number - transport layer Discussions

Write discussion on Source port number - transport layer
Your posts are moderated
Related Questions
What is the meaning of P-persistent If the medium is idle, transmit with probability p, and delay one time unit with probability (1 - p); if the medium is busy, continue to lis

What is the basic difference between latches and flip flops? Ans) flip flops have clock signal whereas latches dont require anyclock pulse..

Token Bus Sublayer Protocol Send for some time then pass token If no data after that pass token right away Traffic classes 0, 2, 4 and 6 (highest) Internal s

Question : a) What does association refer to in IEEE 802.11? b) State the fundamental principles of 3GPP security. c) Explain the term "binding" in Mobile IPv6 d)


As discussed in the earlier section each computer linked to the Internet has a unique address. Let's assume your IP address is 1.2.3.4 & you wish to send a message to the computer


What is piggybacked ACK The protocol will be incorrect. Suppose that 3-bit sequence numbers we are using. Consider following situation: A just send frame 7. B gets frame

Q. What is Boundary Level Masking? If mask numbers are either 255 or 0: Bytes in the IP address that correspond to 255 in the mask will be repeated in the subnet ma

In point-to-point message passing, single process sends/receives message to/from another process. There are four communication modes for sending a message: i)    Buffered mode