Q. Skid assemblies and modular structures?

This specification describes parameters for the design, fabrication, materials and installation of the structural steel part of skid mounted modules. These specifications encompass furnishing of all labour, materials, preparation for transportation, handling, storage, supervision, tools, and other equipment that may be necessary to install the structure as described herein, in associated plans and standard drawings. Foundations are not included.

This specification also provides guidelines and requirements for setting modules on existing foundations constructed by others. Any work that is reasonably implied and necessary for the satisfactory completion shall be performed as though explicitly indicated in this specification or as shown on construction drawings.

Posted Date: 7/8/2013 12:25:04 AM | Location : United States

Ask an Expert

Related Discussions:- Skid assemblies and modular structures, Assignment Help, Ask Question on Skid assemblies and modular structures, Get Answer, Expert's Help, Skid assemblies and modular structures Discussions

Write discussion on Skid assemblies and modular structures
Your posts are moderated

Write your message here..

Related Questions

Remote controlled helicopter, how to start how to start

Upward compatibilityof iges, Upward Compatibilityof IGES Upward Compati... Upward Compatibilityof IGES Upward Compatibility : The need for generations of processors to parse files compliant with earlier versions of IGES thwarted the breadth and rate o

How the drawbacks of WFM technique have been overcome, The drawbacks of WFM... The drawbacks of WFM technique have been overcome Domain While no representation can describe all possible solids, a representation should be able to represent a useful se

Estimate what fraction of heat loss by the fin, A tube assembly constructed... A tube assembly constructed of Cu with an inside diameter of 1.25 cm, wall thickness of 0.8 mm and circumferential fins around the periphery. The fins have thickness of 3 mm, and a

Arc initiation-touch start-high frequency start, ARC INITIATION Touch... ARC INITIATION Touch Start With the power supply energised and the shielding gas flowing through the cup, the torch is lowered toward the workpiece until the tungsten electr

Compare petrol engine with diesel engine, Compare Petrol engine with Diesel... Compare Petrol engine with Diesel engine with each other ( i ) Basic cycle: Petrol Engine work on Otto cycle whereas Diesel Engine work on diesel cycles. ( i i )

Explain types of gas welding process, Types of Gas Welding Process Gas ... Types of Gas Welding Process Gas welding includes all those welding processes in which gas flame is used as a heat source for melting metals. It is further divided into three m

Determine the residual plastic strain in the members, As part of the fitti... As part of the fitting of the mooring lines to a wave energy device, the pin-jointed structure shown in Figure Q is to be subjected to a small degree of plastic deformation by appl

Thermodynamics, describe equivalence of kelvin planck and clausious stateme... describe equivalence of kelvin planck and clausious statement

Efficiency test on sand blasting, Efficiency Test on Sand Blasting:   ... Efficiency Test on Sand Blasting:             After the study on sand blasting, the result was acceptable and the next step is planning to make order for new machine and searc