Sketch their bode plots and compare with the matlab figures, Chemical Engineering

1. Consider the previous heat exchanger.  Tune a proportional controller for a)  GM = 2; PM = 45 degrees and c)  MPH (maximum peak height) occurs at 2 dB (provides a z of ~ 0.4).

2. Consider the following transfer functions.  Neatly sketch their Bode plots and compare with the Matlab figures.

1293_chemical eq. 3.png

Posted Date: 4/6/2013 5:43:24 AM | Location : United States







Related Discussions:- Sketch their bode plots and compare with the matlab figures, Assignment Help, Ask Question on Sketch their bode plots and compare with the matlab figures, Get Answer, Expert's Help, Sketch their bode plots and compare with the matlab figures Discussions

Write discussion on Sketch their bode plots and compare with the matlab figures
Your posts are moderated
Related Questions
Calculate the fugacity of liquid acetone at 110° C and 275 bar. At 110 0C the vapor pressure of acetone is 4.360 bar and the molar volume of saturated liquid acetone is 73 cm 3 /mo

how 2 construct a loci?

how to solve partial differential equation using matlab and also discreteing the pdf in matlab

A single-effect evaporator is used to concentrate 60000 kg h -1 of a 40 wt % NaOH solution which is fed to the evaporator at 40°C. The concentrated liquid is a 55 wt % NaOH soluti

Could help with Hysys design assinment?

describe layout of wet process for portland cement industries ?

Cyclohexane (C 6 H 12 ) is produced by mixing Benzene and hydrogen. A process including a reactor, separator, and recycle stream is used to produce Cyclohexane. The fresh feed cont

What are the design considerations for a piping system for the transfer of slurries? The below points should be considered for designing a piping system to carry slurries: >

#synthesis and uses of westron

Ask queswhat is axontion #Minimum 100 words accepted#