Show the steps used at sender end by check sum, Computer Networking

Assignment Help:

Q. Show the steps used at sender end by check sum?

The sender follows these steps:

The data unit is divided into "k" sections, each off "n" bits
All sections are added using one's complements to get the sum
The sum is complemented and becomes the checksum.
The checksum is appended as well as sent with the data

Related Discussions:- Show the steps used at sender end by check sum

Flow control in TCP, Q. Flow control in TCP? The amount of data a s...

Q. Flow control in TCP? The amount of data a source is able to send before receiving an ACK from the destination Whether to send 1 byte of data as well as wait for ACK

Prepare a lan from a set of stand-alone computers, Question 1: Describe...

Question 1: Describe the following terms in your own words: a. Internet b. WWW c. Intranet

What are the types of transmission media, What are the types of Transmissio...

What are the types of Transmission media? Signals are usually transmitted over some transmission media that are broadly divided in to two categories:- Guided Media: Th

Bandwidth allocation , Consider figure. Assume a new flow E is added that ...

Consider figure. Assume a new flow E is added that takes a path from R1 to R2 to R6. How does the max-min bandwidth allocation change for the 5 flows?

Building and running mpi programs, MPI parallel programs are written with c...

MPI parallel programs are written with conventional languages like, C and Fortran .One or more header files such as "mpi.h" may be needed to give the necessary definitions and dec

Which protocol resolves an ip address to a mac address, The Address Resolut...

The Address Resolution Protocol (ARP) sends out a broadcast to verify the MAC address from the IP address.

Difference between unicast and anycast, Difference between Unicast and Anyc...

Difference between Unicast and Anycast Unicast: An identifier for a single interface. A packet sent to a unicast address is delivered to the interface identified by that addres

Signal to noise ratio, Problem 1. Explain the TCP/IP Reference Model wi...

Problem 1. Explain the TCP/IP Reference Model with diagram 2. Describe the following Maximum Data Rate of a Channel Signal to Noise Ratio 3. Describe the

Explain about multiplicative decrease, Q. Explain about Multiplicative Decr...

Q. Explain about Multiplicative Decrease ? Multiplicative Decrease (MD) if a time-out take places the threshold is set to one maximum segment size (TCP Tahoe, TCP Reno).

Difference between baseband and broadband transmission, What is difference ...

What is difference between baseband and broadband transmission? In a baseband transmission, the whole bandwidth of the cable is consumed by a one signal. In broadband transmiss

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages