Security control procedures , Computer Networking

a) An Introduction/Overview of Network Security issues.

b) A Risk Assessment  analysis- to include:
            Assets                                            
            Threats                                            
        Security Priority Identification
        (In terms of assessing Asset Importance and in terms
        of categoring threats by significance)

c) A discussion of Security Control Procedures for disruption, destruction or disaster  
                                                                                                                                                        

D)A diagram and associated description to illustrate where and what type of security-related hardware and software may be placed and utilised to good effect.
                                                                                                                                                                 

E) A proposed backup plan/schedule for 2 server roles/contexts; so that, in the event of data loss, a Disaster Recovery Plan may be implemented    
                                                                                                                                                        

Posted Date: 3/23/2013 5:47:18 AM | Location : United States







Related Discussions:- Security control procedures , Assignment Help, Ask Question on Security control procedures , Get Answer, Expert's Help, Security control procedures Discussions

Write discussion on Security control procedures
Your posts are moderated
Related Questions
- EIA/ TIA specifies and RJ-45 connector for unshielded twisted-pair (UTP) cable. The letter RJ stand for registered jack and the number 45 refers to a specific wiring sequence.

As discussed in the earlier section each computer linked to the Internet has a unique address. Let's assume your IP address is 1.2.3.4 & you wish to send a message to the computer


Question Approximately what is the low frequency cut-off of the band-pass filter shown in the figure?

What is source route and OSPF? Source route It is a series of IP addresses identifying the route a datagram must follow. A source route might optionally be included in an

Question 1 What does the SNMP access policy represent? Question 2 Does there exist any formal functional specification for SNMPv1 management? Question 3 In the con

UPD is a layer 4 Transport protocol. It is connection-less due to it does establish a connection thus the 3 step handshake is not needed, it does NOT execute any flow control or ac

explain Learning Bridges in deatil.

What is the difference between CSMA/CD and CSMA/CA? CSMA/CD, or Collision Detect, retransmits data frames when a collision occurred. CSMA/CA, or Collision Avoidance, will first

MOSPF MOSPF is multicast extension to OSPF. This protocol is extension of OSPF which is a unicast routing protocol which make MOSPF a combination of unicast and multicast prot