Riveting, Other Engineering

Riveting is a fixed fastening procedure in which the end of the metal pin is pressed over or spread out by hammering operation. Wrought iron and steel are used for the riveting and copper, brass and aluminium are used for cold working. 

Posted Date: 8/3/2012 5:34:24 AM | Location : United States







Related Discussions:- Riveting, Assignment Help, Ask Question on Riveting, Get Answer, Expert's Help, Riveting Discussions

Write discussion on Riveting
Your posts are moderated
Related Questions
What is the difference between real money & nominal money? 1) Nominal cash is related to the measure of counting. Moderate figure is what is written on the bill. Whereas actual

Thrust augmentation: There are occasions when the maximum thrust from a basic gas turbine engine is inadequate and some method of increasing the available thrust is required wi

When a beam of monochromatic x ray is incident on a graphite block, it get scattered and scattered wavelength is larger than that of the incident radiation wavelength. This scatter

PROPELLER CONSTRUCTION METAL PROPELLERS Most metal propellers have forged alloy blades protected from corrosion by anodising and often further protected by polyurethane en

The effect of swell factors on volumes

Electron gun: The electron gun consists of the following: 1.  Cathode:  An indirectly heated cathode (negatively biased w.r.t. the screen). 2.  Grid:          A cylindric


Laser induced breakdown spectroscopy

Bravis lattice or Bravis crystal system: The ideas of space lattice was introduced by Bravis in 1990.According to this there are 14 possible types of space lattices in the seven ba

Force, Moment, Velocity and Angular Velocity Components • Aerodynamic Force Components - X, Y, Z • Velocity Components - U, V, W (or Vx, Vy, Vx) • Angular Velocity Components - P,