Programming languages - introduction to microprocessors , Electrical Engineering

Programming languages

As we  have seen  the evolution of computer  hardware  similarly  programming  languages also  have their  history  of development from  machine  language  to modern languages like C, C++m JAVA etc.  Various  programming  languages are discussed in detail in followings  sections.

Posted Date: 4/4/2013 1:20:36 AM | Location : United States







Related Discussions:- Programming languages - introduction to microprocessors , Assignment Help, Ask Question on Programming languages - introduction to microprocessors , Get Answer, Expert's Help, Programming languages - introduction to microprocessors Discussions

Write discussion on Programming languages - introduction to microprocessors
Your posts are moderated
Related Questions
If a current is passed through a coil, it creates a flux within the coil. Any attempt to change this flux will create a back emf that acts to oppose the change.   Consider again


ACI  Add Immediate with Carry  Instruction Similar  to ADC instruction 8 bit  data specified  in the  instruction and Carry  are added to the contents  of the  accumulator and

Power in Balanced Three-Phase Circuits The total power delivered by a three-phase source, or consumed by a three-phase load, is found simply by adding the power in each of the

Q. Briefly explain about Phasor Method? For sinusoidal excitations of the same frequency, the forced or steady-state responses are better found by the technique known as the ph

The project involves comparisons between di erent sampling methods, di erent estimation methods, numerical results using samples selected from a synthetic nite population, and a

Technical Loss in Electrical Systems Technical loss is inherent in electrical systems, as all electrical devices have a few resistances and the flow of currents causes a power

Discuss important properties and uses of Ceramics. Ceramics - These are materials made by high temperature firing treatment of natural clay and specific inorganic matters. The

In a CDMA system, the signal is spread over a large bandwidth by multiplying the transmitted symbol by a sequence of short pulses, also called chips. The

Refer to Figure 100. Assume MKS units. Given: R1= 4, R2=14, R3= 9, I4= 8, I5= 7. Determine: Ieq, Req, and V3.