Pneumatic actuator design matrix, Applied Statistics

Pneumatic Actuator Design Matrix: The range of actuator design parameters have been provisionally assessed and are presented in Table. You are required to determine the following parameters:

  • The circumferential stress and strain
  • The longitudinal stress and strain
  • The change in cross-sectional area
  • The change in length
  • The change in volume

Your design tasks are:

(i) Prepare a suitable hand-written matrix based on an Excel Worksheet as a planning guide to show the cell locations of all the formulae you consider necessary to determine the specified design parameters.

(ii) Using the planning information from (i) and the associated Design Data presented in Table (2), develop an Excel Worksheet capable of determining the design parameters within the specified ranges and test as appropriate to show all intermediate calculations and associated worksheet OUTPUT DATA.

(iii) Using appropriate INPUT DATA, check the correlation between the Excel Worksheet OUTPUTs and those obtained by manual calculation. Check for errors (if required) either in the worksheet or manual calculations until appropriate correlation is obtained.

(iv) Submit the planning matrix from (i), an operational Excel Worksheet from (ii) showing all the data together with all supporting calculations from (iii).

Posted Date: 3/7/2013 4:07:24 AM | Location : United States







Related Discussions:- Pneumatic actuator design matrix, Assignment Help, Ask Question on Pneumatic actuator design matrix, Get Answer, Expert's Help, Pneumatic actuator design matrix Discussions

Write discussion on Pneumatic actuator design matrix
Your posts are moderated
Related Questions
practical application of standard error

Dr. Jim Mirabella UNIT EIGHT: DATA ANALYSIS PROJECT All Excel output should be copied into a single Word document where you must enter all of your responses to the questions below.

Q. Compute the output of correlation? The following figure shows (a) a 3-bit image of size 5-by-5 image in the square, with x and y coordinates specified, (b) a Laplacian

Steps in ANOVA The three steps which constitute the analysis of variance are as follows: To determine an estimate of the population variance from the variance that exi


(a) If one solves the ordinary differential equation using Euler's method find an expression for the local truncation error. (b) Using the result of (a) above what will

Let X, Y, and Z refer to the three random variables. It is known that Var(X) = 4, Var(Y) = 9, and Var(Z) = 16. It is further known that E(X) = 1, E(Y) = 2, and E(Z) = 4. Furthermor

Test the following claim. Identify the null hypothesis, alternative hypothesis, test statistic, critical value(s), conclusion about the null hypothesis, and final conclusion that

The Null Hypothesis - H0:  The random errors will be normally distributed The Alternative Hypothesis - H1:  The random errors are not normally distributed Reject H0: when P-v

Correlation The board of directors of Bata Company is faced with the problem of estimating what the annual sales might be in a shop to be opened in Bagpur where Bata has not op