Pn diode, Electrical Engineering

PN Diode

The current-voltage characteristics are of major concern in the learning of semiconductor devices with light entering like a third variable in optoelectronics devices. The device's external characteristics are ascertained by the interplay of the following internal variables: 

  1. Electron and hole currents
  2. Potential
  3. Electron and hole density
  4. Doping
  5. Temperature
Posted Date: 1/11/2013 2:09:14 AM | Location : United States







Related Discussions:- Pn diode, Assignment Help, Ask Question on Pn diode, Get Answer, Expert's Help, Pn diode Discussions

Write discussion on Pn diode
Your posts are moderated
Related Questions
Q. Athree-phase, 60-Hz transmission line has a total series impedance of 22.86 62.3°  per phase. It delivers 2.5 MW at 13.8 kV to a load connected to its receiving end. Compute th

(a) What is understand by clipping circuit. Draw and illustrate different types of diode clipping circuits? (b) With the help of circuit diagram describe the working of centre t


what is difference between scot and delta connection.

Q. Introduction to power systems? Thomas A. Edison's work in 1878 on the electric light led to the concept of a centrally located power station with distributed electric power

The normalized signal xn(t) has a bandwidth of 10 kHz and its power content is 0.5 W, while the carrier Ac cos 2πfct has a power content of 200W. Find the bandwidth and the power c

a. Describe why a three-phase induction motor rotates always with a speed less than the synchronous speed. b. State the principle of operation of a capacitor start single-phase

Q. Give the classification of Oscillators?  Depending on the type of the output waveform, oscillators are classified as sinusoidal (or harmonic) oscillators and relaxation osci

POP Instruction This instruction  copies the contents  of the top  two locations  of the  stack into the  specified  register pair. The  contents  of stack pointer register are

Write shorte note on Carbon. Carbon: The rate of commutator wear in electrical machines is greatly decreased by using brushes made of carbon. Carbon (C) is also used in autom