Packet switches, Computer Networking

PACKET SWITCHES:

 To span large distances or several computers, networks must removed shared phase with packet switches. Each switch moves whole packet from one connection to another. That's why they are known as packet switches. A packet switch consists of a small device with network interfaces, a storage and a program dedicated to packet switching application.

A packet switch is given in the figure below.

1469_PACKET SWITCHES.png

 

Posted Date: 10/27/2012 9:27:30 AM | Location : United States







Related Discussions:- Packet switches, Assignment Help, Ask Question on Packet switches, Get Answer, Expert's Help, Packet switches Discussions

Write discussion on Packet switches
Your posts are moderated
Related Questions
State about transcontinental ?ber A transcontinental ?ber link may have many gigabits/sec of the bandwidth, but latency will also be high due to speed of light propagation abov


Data Link Layer Sub layers ·  Logical Link Control (LLC) - upper layer · Handles control information, logical addressing and data · MAC (Medium Access Control) - lower layer ·

What is usage of Sequence Number in Reliable Transmission? The protocol specifies that frames need to be numbered. This is done by using sequence numbers. A field is added to t

Increasingly it is the quality of the interface of mobile phones that are giving competitors the edge.  Users not only make selections based on cost but also functionality and cert

Q. Show the Class A Addresses? Class A Addresses Numerically the lowest Use merely one byte to identify the class type and netid Three bytes are obtainable

What is a Multiplexor

QUESTION (a) What are the problems with IPv4 on today's Internet and how does IPv6 solve these problems? (b) Describe at least three ways in which IPv6 is more efficient tha

DNS ID hacking The Dns use ID system in order to keep track of each every request and replies. In order to spoof the DNS’s response, the hacker needs to do ID Hacking. In orde

Verify VLANs and trunking. Use the show ip interface trunk command on S1 and the show vlan command on S2 to determine that the switches are trunking correctly and the proper VL