Nominal strain and true strain, Mechanical Engineering

Nominal Strain and True Strain:

Nominal Strain is ratio of change in length per initial length.

 Nominal strain =  Change in length / Initial length = ΔL / L

 

Posted Date: 10/20/2012 7:45:01 AM | Location : United States







Related Discussions:- Nominal strain and true strain, Assignment Help, Ask Question on Nominal strain and true strain, Get Answer, Expert's Help, Nominal strain and true strain Discussions

Write discussion on Nominal strain and true strain
Your posts are moderated
Related Questions
Q2.1  Using the stiffness method calculate axial forces and the deflections of the joints of the truss shown in the FIG. The truss was built using 50 mm x 50 mm x 5 mm SHS with  E

Q. Burner Management - Discrete Controls for steam generators? The burner management system shall control the generator operation during pre-purge, light off, normal operation,

Calculate sif of crack - beam: An edge cracked beam carries crack in its central plane whose lengths is 5 mm. A load of 1000 N is applied opposite to crack so that crack would

Explain the study of readial Drilling machine with spindle The objective of this study is to study of readial Drilling machine with spindle. As in Radial Drilling machine th


Rockwel l Hardness Test: The specimen is subjected to a major load for about 15 seconds after the initial load. ASTM says 13 scales for testing of wide range of materials. Th

what are the factors that affecting the fatigue behaviour of materials?

Q. What is Stormwater Treatment? Normally, stormwater run-off from process areas needs to be collected and treated before being discharged to land or water. Often, large aerobi

A large tower is to be supported by a series of steel wires; it is estimated that the load on each wire will be 13,300 N (3000 lb f ). Determine the minimum required wire diameter,

Point of inflexion: Define the term point of contraflexure or point of inflexion. Also define point of zero shear force?  Sol.: The points (other than extreme ends of beam)