Name the default lmi type, Computer Networking

Assignment Help:

Cisco is the defaul LMI type.

There are three types of LMI standards: 

ANSI - Annex D defined by ANSI standard T1.617 

ITU-T (Q.933A) - Annex A defined by Q933A 

Cisco (default) - LMI defined by the gang of four

 


Related Discussions:- Name the default lmi type

Explain the multipath resistance, Explain the Multipath resistance The ...

Explain the Multipath resistance The chipping codes used for CDMA not only exhibit low cross-correlation but also low autocorrelation. Thus, a version of the signal that is del

What are the responsibilities of application layer, What are the responsibi...

What are the responsibilities of Application Layer? The Application Layer enables the user, whether human or software, to access the network. It gives user interfaces and suppo

Error detection-general, Q. Error Detection-General? Sender transmi...

Q. Error Detection-General? Sender transmits every data unit twice Receiver performs bit-by-bit comparison between those two versions of data. Any mismatch would

Fundamental of network , Fundamental of Network The  concept  of netw...

Fundamental of Network The  concept  of network  is not  new. In simple  it means an interconnected set  of some  objects. For decades we are familiar with the radio,  televi

What is the standard isdn term for a native isdn modem, TA is the standard...

TA is the standard ISDN term for a native ISDN modem

Ipv6 - network layer and routing , IPv6 The  internet  engineering task...

IPv6 The  internet  engineering task force begin  the effort to develop a successor  protocols  to IPv4 in the early  1990 is an internet  layer protocols  for packet  switched

State about the communications network, State about the communications netw...

State about the communications network 1) The communications network may only accept blocks of data up to a specific size.   (2) Error control might be more effective with a

5 igrp supports a feature , 5 IGRP supports a feature that permits traffic ...

5 IGRP supports a feature that permits traffic to be distributed among up to 6 (4 default) paths to give greater allover throughput and reliability. What is this called? Ans) An

What does the user datagram protocol (udp) , UDP is connectionless, and doe...

UDP is connectionless, and does not give error checking. But remember, error checking can happen at other layers too.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd