Metering and billing system, Electrical Engineering

Metering and Billing System

Previously, you have learnt about various measures for reducing commercial losses of a utility. You have studied in which the metering and billing system required to be improved substantially. Therefore, here, we focus on this aspect.

With the proliferation of electrically powered devices and systems, there is an increasing required to accurately and precisely measure and monitor the quantity and quality of the electrical power supplying these devices and systems. Here, we begin through describing the metering technologies and techniques currently in use. We then describe calibration and testing of energy meters and metering standards, meter installations practices and field testing. At last, we define certain revenue protection and technology interventions in metering, billing and collection.

Posted Date: 2/6/2013 6:51:13 AM | Location : United States







Related Discussions:- Metering and billing system, Assignment Help, Ask Question on Metering and billing system, Get Answer, Expert's Help, Metering and billing system Discussions

Write discussion on Metering and billing system
Your posts are moderated
Related Questions
Diode Schematic Symbol The diode in figure is a unidirectional device. Electron current just only flows in one direction, against the arrow, corresponding to forward bias. The

Q. (a) A balanced wye-connected load with per-phase impedance of 20 + j10 is connected to a balanced 415-V, three-phase supply through three conductors, each of which has a series

Q. An op amp has a finite gain of only 50, but is otherwise ideal. For the inverting-amplifier circuit of Figure, if R 2 = 20 k, what value of R 1 would be needed to give a gain

What are the Advantages of digital cameras Advantages of digital cameras over manual cameras include: no processing costs (As there is no need to develop film or make prints),

Q. A four-pole, dc seriesmotor has a lap-connected, two-layer armature winding with a total of 400 conductors. Calculate the gross torque developed for a flux per pole of 0.02 Wb a

A 150 km long, 3-phase, 400 kV overhead line is used to transmit 1800 MW to a distribution area at 0.9 power factor lagging. The line parameters per phase and per unit length in st

Discuss classification of conducting materials into low resistivity and high resistivity materials. Conducting materials are categorized as low resistivity materials and high r

1. A 1 μm long and 100 μm 2 cross-sectional area silicon bar is doped with 10 16 /cm 3 phosphorous. Use the graph below to: a. Find the current at 300°K with 10 V applie

Q.   Explain the block diagrtam of D.C. voltmeter with direct coupled amplifier. Sol. D.C, voltmeter with direct coupled Amplifier         The D.C. electronic voltmeters

Q. Use a 4-to-1multiplexer to simulate the following: (a) NAND logic function. (b) EXCLUSIVE-OR logic function. (c) Σ m (1, 2, 4).