Logically and the contents of memory, Electrical Engineering

Logically AND the contents of memory

Contents of memory  location,  whose address is specified by HL register pair are logically AND with the  contents  of the accumulator. The results is stored  in the accumulator. The instruction format is

ANAM                      (A- A & [HL])

Flags :S, Z and P  are modified  according to the result CY  is always  reset. AC   it always set.

 

 

Posted Date: 4/5/2013 12:37:03 AM | Location : United States







Related Discussions:- Logically and the contents of memory, Assignment Help, Ask Question on Logically and the contents of memory, Get Answer, Expert's Help, Logically and the contents of memory Discussions

Write discussion on Logically and the contents of memory
Your posts are moderated
Related Questions

Q. If an analog message that has a spectral extent of 15 kHz is sampled at three times the Nyquist rate, determine the sampling rate.


Parity flag  - Registers If after  any arithmetical or logical operation if  number of  the accumulator  are even  parity  flag (P)  is set otherwise  reset.

Q. Consider the common-source JFET circuit shown in Figure with ?xed bias. Sketch the sinusoidal variations of drain current, drain voltage, and gate voltage superimposed on the di

Q. Write short note on Quantization? Quantization: This is first step in PCM. Total amplitude range of the modulating signal is divided into a number of standard levels calle

READY Input Microprocessor  has to communicate with other  peripherals which  are slow  as compared to the microprocessor. READY  signals  is used to synchronies  these periphe

write a short note on Scale

Q.   Explain the block diagrtam of D.C. voltmeter with direct coupled amplifier. Sol. D.C, voltmeter with direct coupled Amplifier         The D.C. electronic voltmeters

#questsdfsdfsdfsion..