Law of superposition - mechanics, Mechanical Engineering

Law of superposition:

When the two forces are in equilibrium (equal, collinear and opposite), their resultant is zero and their combined action on rigid body is equivalent to that of no force at all. Therefore

The action of the given system of forces on rigid body will not be changed if we add to or subtract from them another system of forces in equilibrium; this is called as law of superposition.

 

 

Posted Date: 10/16/2012 2:14:03 AM | Location : United States







Related Discussions:- Law of superposition - mechanics, Assignment Help, Ask Question on Law of superposition - mechanics, Get Answer, Expert's Help, Law of superposition - mechanics Discussions

Write discussion on Law of superposition - mechanics
Your posts are moderated
Related Questions
Q. What is the use of welding electrode? An electrode is a piece of wire or a rod (of a metal or alloy), with or without flux covering, which carries current for welding. Its o

winter&summer refrigeration .

Q. Tank Insulation process? With Owner's approval, spray urethane foam may be used. Manufacturer's recommendations for service temperature limit shall be followed for specific

Give the assumption of pure torsion derivation of shear stress produced in circular shaft subjected to torsion

Question: A series resistive inductive load is energised from a 240V (RMS), 50Hz single phase AC supply, such that the load draws 1200W at a power factor of 0.8. a) Calculat

how can I determine the relative velocity in mechanism

Find the value of force to move a system: Th e system of particles shown in the figure given below is initially at rest. Find the value of force F which should be applied so


Explain which laws of physics are used to discuss heat loss in a pipe, and briefly explain how the famous equation for the loss of heat in a cylindrical pipe is derived. Explain th

The Radial Dimension Commands There are 2 main radial dimension commands, DIMDIAMETER & DIMRADIUS. Both commands result in  similar looking dimension so AutoCAD automatically i