Introduction to welding processes, Mechanical Engineering

Welding is a material joining process used in making welds and a weld is a localised coalescence of metals or non metals produced either by heating the materials to suitable temperature with or without the application of pressure or by the application of pressure alone and with or without the use of filler material.

 

The various welding processes can be classified in many ways. They can be based on energy transfer, type of welding or mode of welding.

 

 

 

Posted Date: 9/13/2012 3:06:37 AM | Location : United States







Related Discussions:- Introduction to welding processes, Assignment Help, Ask Question on Introduction to welding processes, Get Answer, Expert's Help, Introduction to welding processes Discussions

Write discussion on Introduction to welding processes
Your posts are moderated
Related Questions
What is maximum shear stress in mechanics of materials ? Derivation for maximum and minimum shear stress seperately.

(a) Describe and calculate i) Humidity Ratio ii) DPT iii) Relative Humidity iv) Density v) Enthalpy of atmosphere air when DBT is 35 0 C, WBT is 23 0 C and the ba

What are the two ways of pile foundation Pile foundations can be installed in two ways. Timber, steel and precast concrete piles, are driven from the ground using hammers till

Q. Categorization of Geometric models? Modern CAD systems define objects in 3-D. Thus, the designer can construct 3-D model of objects conveniently and store the database of th

LASER WELD OVERLAY I CLADDING This process brings the metal surface to a substantially higher temperature than in the heat treating process and results in a thin molten surface

Does the selected system meet the requirements of the application (building purging, make-up air, filtration, ventilation)? Is the system suitable for the intended building usag

A positive displacement pump is a liquid or gas to move by trapping a fixed amount of fluid or gas and then forcing (displacing) that trapped volume into the discharge pipe. Positi

Q. Design an Evaporator System? The Evaporator System is designed to produce high quality distillate. The feed water to the evaporator system is dosed with antiscalant and rece

Q. What is Injection moulding? An important industrial method of producing articles of thermoplastics is injection moulding. The moulding material is loaded into a hopper from

It is estimated that the average number of surface defects in 20 square meter of paper produced by process is 3.what is probability of finding number more than 2 defects in 40 squa