Inspection of casting, Other Engineering

Inspection of casting  

  1.         Visual inspection
  2.         Inspection for dimensional accuracy.
  3.            Sound test
  4.            Pressure test
  5.          Impact test
  6.         Radiography or X-ray tests
  7.           Penetrant testing
  8.          Magnetic particle testing
  9.         Ultrasonic testing
Posted Date: 8/3/2012 1:45:11 AM | Location : United States







Related Discussions:- Inspection of casting, Assignment Help, Ask Question on Inspection of casting, Get Answer, Expert's Help, Inspection of casting Discussions

Write discussion on Inspection of casting
Your posts are moderated
Related Questions
Combustion process: Air from the engine compressor enters the combustion chamber at a velocity up to 500 feet per second, but because at this velocity the air speed is far too

2. Differentiate between stream oriented and data gram oriented socket in java?

a note on tracing a closed loop. What are the characteristic features of a closed loop?(

Lifting wing FP was run at the conditions corresponding to AGARD WG07 TEST CASE 11, namely M∞ = 0.84,α= 3.06 deg. The ‘final step' values of the partially-conservative paramete

Replacement Analysis In the previous chapter we have compared various investment alternatives. Two scenarios were considered: single alternative and a set of mutually exclusive

conclusion for epithelial tissue

i want to do aeronautics engg. but my height is only five feet . so can i go in aeronautics

how can we find local attraction correction?

Water enters a smooth thin-walled tube of 1 inch diameter at 50F and leaves at 150F. Heat is supplied to the water by condensing steam on the surface of the tube at a constant temp

Cash Flow Diagrams We will use a cash flow approach to analyze the flow of money through out a planning horizon. A cash flow occurs when money actually change hands. We will u