Improvement of existing airport, Mechanical Engineering

Improvement Of Existing Airport:

The improvements that are usually needed for existing airports fall under the following categories :

(a)        Extension of runway to accommodate bigger aircraft.

(b)       Strengthening of pavement to cater to heavier aircraft.

(c)        Provision of modern facilities for landing (such as Instrument Landing Facility).

(d)       Modernisation of terminal building to accommodate more passengers and to upgrade the facilities.

Posted Date: 1/23/2013 1:37:27 AM | Location : United States







Related Discussions:- Improvement of existing airport, Assignment Help, Ask Question on Improvement of existing airport, Get Answer, Expert's Help, Improvement of existing airport Discussions

Write discussion on Improvement of existing airport
Your posts are moderated
Related Questions
Explain Zeroth law and 1 st law of thermodynamics. Describe Internal energy and Enthalpy. What is a PMMFK. Give the expression for reversible workdone in a thermodynamic system

Determine the component of force: The force of 500N is acting at a point subtends an angle of 60° with the horizontal. Determine the component of force along X and Y dire

The temperature limits of an ammonia refrigerating system are 25 O C and - 10 O C. if the gas is dry at the end of compression, determine the coefficient of performance of the cycl

For fan installation detail and indicate correct structural components, drip pan, acoustical and thermal insulation. Provide special acoustical curbs for critical areas. Chec

Explain the construction and principles of operations of induction motor

derive an expression for the fundamental frequency of sound obtainable from a tube given diameter open at one end

A pump station has been designed to lift water out of a 6 metre deep pit (vented to atmosphere) via a centrifigual pump mounted at ground level.                    Liquid condit

What are the Alluvial sediments Alluvial sediments are characterized by stratification or layering and fine grained soil layers have higher compressibility as compared to coars

please help me to calculate the diameter of a brake drum for using in a "brake drum dynamometer engine test rig" the engine specs are as follows: - 6Hp single cylinder 4stroke engi

(a) Following consideration were recorder during a test on a single cylinder oil engine : Bore = 300 mm; speed =300 r.p.r.; stroke = 450 mm;  net break load = 1.5KN;