Imperfect frame - truss, Mechanical Engineering

Imperfect Frame - truss:

Imperfect Frame

An Imperfect frame is one that does not satisfies relation between numbers of members and number of joints given by equation n = 2j - 3.

This means that the number of member in an imperfect frame will be more or less than (2j-3) It can be a deficient frame or redundant frame.

 

Posted Date: 10/20/2012 2:15:29 AM | Location : United States







Related Discussions:- Imperfect frame - truss, Assignment Help, Ask Question on Imperfect frame - truss, Get Answer, Expert's Help, Imperfect frame - truss Discussions

Write discussion on Imperfect frame - truss
Your posts are moderated
Related Questions
Keywords: Degree of Curve      :            The angle subtended at the centre by a chord of 100 ft (30.5 m) length. Super-elevation (cant)        :            The raising


1. Plot the functions x1 and x as functions of voltage 2. Assume that you hold the membrane potential V at -120 mV until the system reaches equilibrium (i.e. until dx=dt = 0, w

Natur e of Distribution of Bending Stress Figure Nature of stress distribution in section of a beam It will be proved that bending stress at any layer of section o

Torsion of a Cylinder Let a cylinder of length  l  and radius  R  be clamped at one end and twisted at the other end by applying a torque τ about the axis of the cylinder. Each

Connecte d Rod: It is attached to piston at its small end by means of gudgeon pin. The big end bearing is connected to crank pin. It is made up of forged steel.

In most hardware stores, you can find what has known as a Heat Gun. Hold the heat gun about 6 inches away from the acrylic you intend on bending say the bumper on a car. They are p

The space truss is supported by a ball-and-socket joint at D and short links at C and E. Determine the force and stress in each member and state if the members are buckle or

Write short notes on following terms:- (i) Total quality management (ii) Method study (iii) Selective Inventory Control (iv) Break Even analysis (v) Merits Rating an

How to design pressure control valve drill plug? How to select stroke and hole diameter and quantity?