Grid resistor, Physics

For higher current rating application, resistance wires with extremely large cross sections are required. The necessary large cross sections are produced in the form of resistance grid. These grids are either cast from iron or stamped from a suitable grade of alloyed stainless steel. These are then assembled by having series and parallel connections into resistor banks of the appropriate resistance and current rating.



Posted Date: 7/9/2012 5:04:58 AM | Location : United States

Related Discussions:- Grid resistor, Assignment Help, Ask Question on Grid resistor, Get Answer, Expert's Help, Grid resistor Discussions

Write discussion on Grid resistor
Your posts are moderated
Related Questions
why deflection magnetometer can not be worked at poles?

How do I make a terrestrial telescope?

UV radiations and  X - rays are: UV radiations are produced by the high energy transitions of the electrons in atoms. UV radiations have wavelengths ranging from 0.4 m m to 1n

Q. Illustrate how do you compute shaft power? Answer:- Shaft power P = (2(pi) * (angular Speed in rpm) * (Torque at shaft))/ 60 Torque of a solid shaft is specified by

kelvin; K (after Lord Kelvin, 1824-1907): The basic SI unit of thermodynamic temperature explained as 1/273.16 of the thermodynamic temperature of the triple point of water.

A load of P59 kN acts at right angles to the beam AB.  The angle of the beam to a horizontal x axis at A is P60. The supports are a pin joint at A and a Rocker at B.  Determine the

Explain New Terms for Describing Motion As mentioned in the last chapter, the mass of a cannonball is a measure of the amount of matter (in kilograms) that would balance agains

a loaded cart has a mass of 227kg. if a 312n force acting at an angle of 30degree to the ground is applied. how much work is done in moving the cart 15meters?

Illustrate the demerits of ultrasonic magnetostriction method. Limitations of ultrasonic magnetostriction method: a. This can produce frequencies up to 3 MHz simply. b.