Give shear force and bending moment diagrams, Mechanical Engineering

A simply supported beam ABC with supports at A and B , 6m apart and with an overhang BC 2 metres long takes uniformly distributed load of 1.5 KN/metre length over the entair length. Show the Shear force and Bending Moment diagrams.

Related Discussions:- Give shear force and bending moment diagrams

Laser surface treatment-transformation hardening, Transformation Hardening ...

Transformation Hardening The main features of the laser as a heat source for transformation hardening are: (A) Clean energy source. (B) Energy is localised: no heat spillage.

Nitrides-silicides and sulfides, Nitrides, Silicides and Sulfides Nitr...

Nitrides, Silicides and Sulfides Nitrides contain very high melting point but initiate to oxidize at low temperature. They have poor resistance also to chemicals. Boron nitrid

What do you know about direct welds, Q. What do you know about Direct welds...

Q. What do you know about Direct welds? It is a welding method in which one or more electrodes oppose each other, contacting both sides of the work and with the current passing

Explain gated pattern, Gated pattern This is an improvement over the si...

Gated pattern This is an improvement over the simple pattern where the gating and runner system are integral with the pattern. This would eliminate the hand cutting of the runn

Computer control of machines and processes, Consider a car of mass m1 is to...

Consider a car of mass m1 is towing a trailer of mass m2 through a tow bar of stiffness k. Drag forces proportional to the car velocity (b1 v1) and the trailer velocity (b2 v2) a

Coplanar and non-coplanar forces, Coplanar and Non-Coplanar Forces: In...

Coplanar and Non-Coplanar Forces: In this unit, you have learnt to identify the different systems of forces. You have also learnt the many techniques of adding the forces to g

CRANK SHAFT, TO FIND THE MAGNITUDE OF CRANK SHAFT

TO FIND THE MAGNITUDE OF CRANK SHAFT

Components vs. Parts, What is the difference between a mechanical component...

What is the difference between a mechanical component and a mechanical part?

Stress strain, 1. Determine young''s modulus using first 20 data points 2....

1. Determine young''s modulus using first 20 data points 2. Determine yield strain and yield stress based on -0.1 offset 3. Determine max(or min) stress. 4. Determine toughness

Use of auger extension for extended screed, Use of Auger extension for exte...

Use of Auger extension for extended screed An improved extended auger arrangement and an improved asphalt paver with a tractor unit and a screed assembly including a main scree

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages