Friction is desirable, Mechanical Engineering

Friction is Desirable:

A friction is much desirable to stop the body from its moving condition. If there is no friction between contact surfaces, then the body cannot be stopped without the application of external force. At the same time a person cannot walk on the ground if there is no friction between ground and our legs also no vehicle can run on ground without help of friction.

 

 

Posted Date: 10/17/2012 6:24:29 AM | Location : United States







Related Discussions:- Friction is desirable, Assignment Help, Ask Question on Friction is desirable, Get Answer, Expert's Help, Friction is desirable Discussions

Write discussion on Friction is desirable
Your posts are moderated
Related Questions
Mechanical failure is one of the most important factors causing component/structure/product no longer fit for its intended purpose. Use examples to explain at least three modes o

A jet strikes tangentially a smooth curved vane moving in the similar direction as the jet, and the jet gets reversed in the direction. Prove that the maximum efficiency is slightl

Consider radar with a PRF of 5 kHz. What is the maximum unambiguous range R ua of this radar, in km?  If a target is located at a range of 50 miles, how many pulses will the r

Example of Manufacturing Lead Time (MLT) A certain part is generated in a batch size of 100 units. The batch should be routed through five operations to complete the processin

F AC T OR S AFFECTING THE SELECTION OF BOILER: -     Working Pressure and amount of steam needed. -     Floor area required. -     Operating and Maintenance Required

Could I have 3 topic ideas with problem statement and research questions for each to pick one and send it to the expert? I have a project in Manufacturing Engineering, Master leve

Determine a real root of the equation xlog10 x = 1.2 by regula-falsi method correct to four decimal places.


Q. Flange Assembly with Bolt Tensioning? Measure the free length of the bolts ultrasonically. This must be done prior to applying any load to the bolt. Install bolts on the

Two shafts A and B are co-axial. A gear C (50 teeth) is rigidly mounted on shaft A. A compound gear D-E gears with C and an internal gear G. D has 20 teeth and gears with C and E h