impartance of moulding sand

Posted Date: 8/19/2013 11:33:54 AM | Location : USA

Ask an Expert

Related Discussions:- foundary, Assignment Help, Ask Question on foundary, Get Answer, Expert's Help, foundary Discussions

Write discussion on foundary
Your posts are moderated

Write your message here..

Related Questions

Titanium alloys, Titanium Alloys Pure titanium is a light weight and s... Titanium Alloys Pure titanium is a light weight and strong ductile metal. This is very strong and as well as highly resistant to corrosion of all kinds but has the drawback su

Identification of pressure welds, Q. Identification of Pressure Welds? ... Q. Identification of Pressure Welds? Pressure welds shall be identified as follows: a. Generally each weld shall be stamped adjacent to the weld with the welder's identity c

Determine force on a body to pull or push, Determine force on a body to pul... Determine force on a body to pull or push: Q: A wooden block having weight of 50N rests on the horizontal plane. Determine force required which is acted at an angle of 15° to

Control, hey i really need someone to help doing my control course work asa... hey i really need someone to help doing my control course work asap cuse it is due sunday it is about Control of water level in a nonlinear ‘V’ shaped tank

Illustrate torsionally equivalent shaft, (a) Illustrate Torsionally Equival... (a) Illustrate Torsionally Equivalent shaft. (b) Determine the natural frequencies and mode shapes for the system shown in figure I 1 = 10 Kg -m 2 I 2 = 40 Kg -m 2

Torsion, whta is tortion whta is tortion

Dry friction, Dry Friction: Dry friction (also called as coulomb fr... Dry Friction: Dry friction (also called as coulomb friction manifests when the contact surfaces are dry and there is tendency for the relative motion. Dry friction is fu

2R-2P, EXPLANE PLZZ EXPLANE PLZZ

Lap-type flange-to-shell clearance, Q. Lap-Type Flange-To-Shell Clearance? ... Q. Lap-Type Flange-To-Shell Clearance? Lap-Type Flange-To-Shell Clearance The difference between the flange ID and the shell OD shall not exceed: • 1/16 in (1.6 mm) for n

Thermal systems, A motor coil can be modeled as a hollow copper cylinder wi... A motor coil can be modeled as a hollow copper cylinder with an outer diameter of 50 mm, an inner diameter of 40 mm, and a length of 60 mm. The motor stalls at time t ¼ 0 and, at t