Fluid Mechanics, Civil Engineering

A 4-m-long, 6-cm-diameter cylinder placed normal to the flow is used to measure the velocity of an air stream. If a force of 50 N is measured, the air velocity is nearest (for air use v = 1.5 x 10^-5 m2/s, and roe= 1.2 kg/m3
Posted Date: 12/4/2012 3:32:33 PM | Location : United States





I have narrowed it down to either 9.27 11.8 18.6 or 24.1
Posted by Kyle | Posted Date: 12/5/2012 2:18:44 AM


Related Discussions:- Fluid Mechanics, Assignment Help, Ask Question on Fluid Mechanics, Get Answer, Expert's Help, Fluid Mechanics Discussions

Write discussion on Fluid Mechanics
Your posts are moderated
Related Questions
Determine the moment of inertia with respect to the x axis for the shaded area shown (Figure 2) . The dimension is a = 2.00m

What is Bore Hole In exploration of  area of  limited extent  the borings should preferably be located near the comers of  the area. A minimum of three holes should be made un

Uses of Stones Stones are used in the following civil engineering constructions are described: (i) Stone masonry which is used for the construction of foundations, , columns

Roads in Deserts: Problems Encountered The western portion of Rajasthan is part of the Thar desert, where strong winds below the fine desert sand particles leading to

Ground settlement occurs when pipe-jacking machine enters mixed ground with soils and boulders? The rate of cutting through soils is faster than cutting through boulders for pi

Q. Reasons for blockage in pumping concrete ? Concrete pumping is normally adopted in highly elevated locations for which access for concrete trucks is difficult. Construction


Question What are main dissimilarities in function between rock anchors and rock sockets ? Answer Rock anchors are used first and foremost for resisting uplift forc

IN CASE CUBE IS FAIL WHAT CAN IDO

where we can overlap steel in columns if we use 50 or 60 bar diameter as overlap length.