Explain indirect data addressing mode, Electrical Engineering

Assignment Help:

Explain indirect data addressing mode (with examples) available in microprocessors.

Indirect Mode:

  • Address given in instruction includes address where the operand resides.

Illustration:

LDAC @5 or LDAC (5)

Retrieves contents of location 5, uses this to access memory address.


Related Discussions:- Explain indirect data addressing mode

Determine the mechanism of generation of the voltage, (a) Identify the semi...

(a) Identify the semiconductor type in the above diagram. (b) Explain the mechanism of generation of the voltage V AB in the above diagram. (c) An experimental setup like th

What is voltage multiplying dacs, What is Voltage Multiplying DACs? Mul...

What is Voltage Multiplying DACs? Multiplying DACs function on the principle of producing a weighted sum analog signal where the sum is proportional to the digital input signal

Calculate the rms voltage generated in each phase, Q. Consider an elementar...

Q. Consider an elementary three-phase, four-pole alternator with a wye-connected armature winding, consisting of full-pitch concentrated coils.  Each phase coil has three turns,

What is the use of 8251 chip, What is the use of 8251 chip? 8251 chip i...

What is the use of 8251 chip? 8251 chip is mostly used as the asynchronous serial interface among the processor and the external equipment.

Determine the expected voltage levels at the output, The subsequent voltage...

The subsequent voltage-source multiplying DAC is to be utilized to convert the digital data stream "11" and "01" to an analog signal.  It has 2-bit inputs and hence is capable of c

How to calculate the bus - bar voltage and kilowatt output., Q.   Two shunt...

Q.   Two shunt wound generators running in parallel supply a total load current of 4000 A. Each generator has an armature resistance of 0.02? and a field of 40?. The fiels are exci

Mov instruction, MOV Instruction Op code  format  of MOV  instruction i...

MOV Instruction Op code  format  of MOV  instruction is as follows : Replace the  codes of destination register and source  register with code of  required  register from.

When both mt2 and gate are positive, When both  MT 2 and  Gate  are pos...

When both  MT 2 and  Gate  are positive In this  junction  P 1 N 1   and P 2 N 2   are forward  biased whereas junction N 1 P 2 is reverse biased. The gate current flows  thr

Find the per-phase impedance of the load, Q. The two-wattmeter method for m...

Q. The two-wattmeter method for measuring three-phase power is applied on a balanced wye-connected load, and the readings are given by W C = 836W and W A = 224 W If the system

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd