electronics, Electrical Engineering

Assignment Help:
why bypass capacitor is used

Related Discussions:- electronics

logical and with accumulator instruction , ANA  Logical AND with Accumula...

ANA  Logical AND with Accumulator Instruction This  instruction is used to logically AND the accumulator  of any register or memory location  with the  accumulator and the r

Dc link scherbius drive - motor control , DC Link Scherbius Drive This ...

DC Link Scherbius Drive This type of scheme is shown in figure. This circuit  allows both  sub synchronous  and super synchronous speed control. In case  of sub synchronous spe

Determine the required voltage at the high-voltage terminals, Q. A 20-kVA, ...

Q. A 20-kVA, 2200:220-V, 60-Hz, single-phase transformer has these parameters: Resistance of the 2200-V winding R1 = 2.50  Resistance of the 220-V winding R2 = 0.03  Lea

Draw circuit diagrams and show polarity markings, Q. Two single-phase trans...

Q. Two single-phase transformers, each rated 2400: 120-V, are to be interconnected for (a) 4800:240- V operation, and (b) 2400:120-V operation. Draw circuit diagrams and show polar

What is the use of modem control unit in 8251, What is the use of modem con...

What is the use of modem control unit in 8251? The modem control unit handles the modem handshake signals to coordinate the communication among the modem and the USART.

What do you mean by dearness allowance, Q. What do you mean by Dearness All...

Q. What do you mean by Dearness Allowance? Ans: Dearness Allowance is in the type of compensation for Established increase in the cost of living and comprised of Dearness All

Compute the efficiency of the motor, Q. A 10-hp, 230-V dc shunt motor takes...

Q. A 10-hp, 230-V dc shunt motor takes a full- load line current of 40 A. The armature and field resistances are 0.25 and 230 , respectively. The total brush-contact drop is 2 V,

Speed control of dc motor using pid, The objective of the project is to pro...

The objective of the project is to protect damage of the DC motors. If the motor is not working it will be shown with red light, if working normally then green and if working at a

Determine the effective input noise temperature, Q Determine the effective ...

Q Determine the effective input noise temperature of a long piece of waveguide (that connects an antenna to a receiver) with a loss of 3.4 dB at 12 GHz and a physical temperature o

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd