electrical machine, Electrical Engineering

Design a suitable double –layer lap winding for a 6-pole dc armature with 18 slots and two coil sides per slot. Give values of front-pitch, brack–pitch and commutator pitch. Draw the developed diagram and show the positions of brushes.
Posted Date: 3/23/2013 3:15:03 AM | Location : USA







Related Discussions:- electrical machine, Assignment Help, Ask Question on electrical machine, Get Answer, Expert's Help, electrical machine Discussions

Write discussion on electrical machine
Your posts are moderated
Related Questions
Define Gain and Phase Responses? Expressing H(e j? ) in polar form as:   H (e j? ) = G (?) e jφ(?) G(?) is the "gain" of the discrete-time system and  φ(?) is the "phas

Metal Oxide Field Effect Transistor The metal-oxide-semiconductor field-effect transistor (MOSFET/MOS-FET/MOS FET) is a device employed for amplifying or for switching electr

Design 8:1 Mux for a given function, f=Σ (0, 1,5,7,9, 13)

Q. What are the Current relations in common emitter configuration? In a CB configuration Ie is the input current and Ic is the output current. These currents are relayed throug

Q. A 5-kVA, 480:120-V, two-winding, 60-Hz, single-phase transformer has an efficiency of 95% while delivering rated load at rated voltage and 0.8 power factor lagging. This transfo

INTRODUCTION : Electricity is one of the finest gifts of science to the mankind since just a flick of switch can flood the room with light or put on a fan, an air conditioner or a

A three-phase transposed line is composed of one conductor per phase with flat horizontal spacing of 11 m as shown in Figure 1(a). The conductors have a diameter of 3.625 cm and a

The one line diagram of a simple power system is shown below.  The data of the system are given in the table below.  (a) Draw the impedance diagram of the system and mark all im

Explain the TEST instruction. TEST: The TEST instruction executes the AND operation. The difference is as the AND instruction changes the destination operand, whereas the TEST

A switch-mode power supply is to be designed with the following specifications: input voltage V s = 48 V ± 10%, output voltage V o = 5 V, switching frequency f s = 100 kHz, outp