Electrical, Engineering Mathematics

The P.D. at the feeder end of a two wire d.c. distributor is 600 volts. Two loads are connected to the distributor at distances of 600 feet and 1000 feet from the feeder end and the currents through the loads are 120 amps and 180 amps respectively. If the resistance of the cable is 0.01 ohms per 100 feet, calculate the p.d. across each load.
Posted Date: 8/10/2012 6:51:25 AM | Location : United States







Related Discussions:- Electrical, Assignment Help, Ask Question on Electrical, Get Answer, Expert's Help, Electrical Discussions

Write discussion on Electrical
Your posts are moderated
Related Questions
A) For a given integer n, if n   2 is divisible by 4, then n2   4 is divisible by 16. State the hypothesis of this sentence and the conclusion. Give a direct proof of the statement

Question 1 Find all solutions of the following equations in the interval [0, 2π) (a) sin(2x) = √2 cos(x). (b) 2 cos 2 (x) + 3 sin(x) = 3. 2. Sketch the graph of the ci

A house wall may be approximated as two 1.2 cm layers of fiber insulating board, a 8 cm layer of loosely packed asbestos, and 10 cm layer of common brick. Assuming convective heat

Code and test Jacobi and Gauss-Sidel solvers for arbitrary diagonally dominant linear systems.

analyn bought a dining set.She paid 2500 as a downpayment and promised to pay 800 @ the end of each month for year.What s the cash eqivalent of the set if the interest rate is 10%

Define a mapping from the x,y plane to the u,v plane by u = 2x + y, v = -x +2y . If a temperature function is given in the x,y plane by T(x,y) = x+y, what is the value, to 3 de

Hello, i need please Matlab Code for DUAL SLOPE DAC. Thanks Marcel

a restrained steel bar is heated from 20 degrees to 194 degrees and not permitted to expand. the bar is 10mm diameter, determine the thermal stress in the bar

r u there?

A new gantry crane for a metal fabrication shop is to be designed. The designer has proposed the following two different configurations: A. Using only truss elements B. Using the