Determine the number of bolts required, Mechanical Engineering

The following specification is used for the design of a flanged coupling between two coaxial shafts:

Speed: 650rpm

Power transmitted: 550 kW

Bolt Diameter: 12 mm

Pitch-circle diameter: 200 mm

Material: Mild steel, Factor of safety =4

Determine the number of bolts required, assuming the bolts are equally loaded.

Posted Date: 3/25/2013 1:42:28 AM | Location : United States







Related Discussions:- Determine the number of bolts required, Assignment Help, Ask Question on Determine the number of bolts required, Get Answer, Expert's Help, Determine the number of bolts required Discussions

Write discussion on Determine the number of bolts required
Your posts are moderated
Related Questions
PROBLEM 1 (30 points) Consider a Boeing 747-400 at weight close to the maximum takeo? weight (MTOW) cruising at Mach 0.82 at an altitude of 32000 ft. (a) How much thrust is needed

when the water is artificially pressurized in a water turbine, what is its power and the speed of rotation of a rotor?

Assumptions made in deriving torsional formulas: What are assumptions made in deriving torsional formulas?                                           Sol.: The torsion

1.5kw/ton of refrigeration is required to maintain temp of -40c in the refrigerator.if the cycle works on carnot cycle.determine 1.cop,2.sink temp 3. heat rejejected to the sink/to

Cylinder - Part of combustion engine: Cylinder: It provides cylindrical closed space to allow movement of piston and to admit charge. It is made up of grey cast iron or i

how we can design a shaft for gear box

I need to have a matlab code with torque and force as differential constraint equations and tractrix constraint also included. The motion may be in a plane and with 5 or 6 links in

As shown in the figure, the jet transport B is flying north with a velocity vB = 600 km/h when a smaller aircraft A passes underneath the transport headed in the 60 degree directio

Write short notes on following terms:- (i) Total quality management (ii) Method study (iii) Selective Inventory Control (iv) Break Even analysis (v) Merits Rating an

Determine the width and depth of the beam: A timber beam of rectangular section is only supported over a span of 5 m. It carries an uniformly distributed load of 15 kN/m over