Determine sliding velocity, Mechanical Engineering

Assignment Help:

a) A pair of 20 degree full depth involute spur gears having 30 and 50 teeth respectively of module 4mm are in mesh. The smaller gear rotates at 1000 rpm. Determine-

1) Contact Ratio 15 

2) Sliding velocity at engagement and at disengagement of pair of a teeth.

b) Two spur wheels have 30 teeth each of involute shape. The circular pitch is 25mm and pressure angle is 20 degree. Evaluate the addendum of the wheels, if the arc of contact is twice the circular pitch.


Related Discussions:- Determine sliding velocity

Mechanics hypothesis-the nano-scale mechanics , Study literature and give a...

Study literature and give a discussion of the applicability of the continuum mechanics hypothesis to the nano-scale mechanics (solids and fluids). Your paper must be detailed but c

Storage & quality of co2 gas, STORAGE & QUALITY OF CO 2 GAS CO 2 gas ...

STORAGE & QUALITY OF CO 2 GAS CO 2 gas is supplied in cylinders at a  high pressure (140 kg / cm 2 ). When the cylinder is full, nearly 90 % of the volume is filled with CO 2

Evaluate natural frequency of damped vibrations, What are various types of ...

What are various types of damping ? Explain viscous damping. A vibrating system is defined by the following parameters : m = 4Kg, K = 10N/m, C =3N-Sec/m Evaluate (a) Na

Find out m.i. of t section, Q. Find out M.I. of T section as shown in figur...

Q. Find out M.I. of T section as shown in figure given below about X - X and Y - Y axis through center of gravity of the section.   Figure Sol.:

Surface modeling, SURFACE MODELING: The process of modeling is built m...

SURFACE MODELING: The process of modeling is built much easier for a mathematical description of an object or at least on a part of the object might be applied. Surfaces might

What is stormwater treatment, Q. What is Stormwater Treatment? Normally...

Q. What is Stormwater Treatment? Normally, stormwater run-off from process areas needs to be collected and treated before being discharged to land or water. Often, large aerobi

Explain soft or flexible automation, Explain Soft or Flexible Automation? ...

Explain Soft or Flexible Automation? This system uses tape, a hand-held control box, microprocessors, programmable logic controllers or computers. The system can be reprogramme

Vessels resting on concrete foundations, Q. Vessels resting on concrete fou...

Q. Vessels resting on concrete foundations? For vessels resting on concrete foundations, the allowable concrete bearing stress shall be 750 psi (5 MPa). The design loadings fo

Bolt stress to seat the gasket, Q. Bolt Stress to Seat the Gasket? The ...

Q. Bolt Stress to Seat the Gasket? The required bolt stress to seat the gasket can be calculated, using the recommended gasket seating stress provided by the manufacturer in ac

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd