Design three-bit counter using t flip-flops, Electrical Engineering

(a) A universal shift register can shift in both the left-to-right and right-to-left directions, and it has parallel-load capability. Draw a circuit for such a shift register.

(b) Design a three-bit counter using T flip-flops. It should include a control input called Up‾/Down. If Up‾/Down = 0, then the circuit should behave as an up-counter. If Up‾/Down= 1, then the circuit should behave as a down-counter.

 

Posted Date: 2/16/2013 3:16:58 AM | Location : United States







Related Discussions:- Design three-bit counter using t flip-flops, Assignment Help, Ask Question on Design three-bit counter using t flip-flops, Get Answer, Expert's Help, Design three-bit counter using t flip-flops Discussions

Write discussion on Design three-bit counter using t flip-flops
Your posts are moderated
Related Questions
Explain what is Linker? Linker: A huge program is divided in smaller programs termed as modules. A linker is a program that links smaller programs together to by a large prog

Q. Draw a block diagramfor a 2-to-4 decoder. Obtain the truth table, and develop a logic diagram.

Q. In the circuit shown in Figure, use the ideal op-amp technique to find: (a) v o as a function of v i . (b) The voltage at A.

Consider a colloidal suspension of latex particles confined between two plates. The plates are charged, so there is an electric potential difference V between them (as shown). The

WHAT ABOUT THE STABILITY IF WE USE COMPENSATOR

Configured dual processor architecture  In centralized SPC, dual processor architecture can be configured to operate in following one of three modes: 1.  Standby mode: In

Energy Conservation Building Codes It encompass the norms and standards of energy consumption expressed in terms of per square meter of the area wherein energy is used. The

Q. For a part of the network shown in Figure, given that i 1 = 4A; i 3 (t) = 5e -t , and i 4 (t) = 10 cos 2t, find v 1 , v 2 , v 3 , v 4 , i 2 , and i 5 .

Q. ADMM (digital multi meter) reads true rms values of current. If the peak value of each of the following periodic current waves is 5 A, find the meter reading for: (a) a sine wav

Program counter holds the address of either the first byte of the next instruction to be fetched for implementation or the address of the next byte of a multi byte instruction, whi