Design the user interface for mode switching, Computer Networking

Design the user interface for mode switching and data entry any way that you like. For example, to switch an application from transmit mode to receive mode, you can give it special input or send it a signal (e.g., SIGUSR1). Make sure that your instructions in the README ?le plus the application's prompting and help facilities (if any) make the application simple to use.

Posted Date: 3/15/2013 1:06:53 AM | Location : United States







Related Discussions:- Design the user interface for mode switching, Assignment Help, Ask Question on Design the user interface for mode switching, Get Answer, Expert's Help, Design the user interface for mode switching Discussions

Write discussion on Design the user interface for mode switching
Your posts are moderated
Related Questions
Byte Number TCP number all data  bytes that  are transmitted  in a connection. Numbering  is independent  in each direction when TCP receives bytes of data  a process. It stor

Determine the Application areas of intranet The uses of an Intranet are only limited by imagination. Some of the larger sectors where the Intranet can be easily and success fu

Q. What is Shielded Twisted Pair? - A metal foil or braided-mesh covering encases every pair of insulated conductors to prevent electromagnetic noise called crosstalk - Cros

Notice repetition of information in routing table for node 1 as given above in the figure. We can see that switch has only outgoing connection, all traffic must goes that connec

INTERNETWORKING - TCP/IP 1. State the following terminologies: a) Node b) Router c) Host d) Subnet e) Network 2. What do you understand by IEEE 802 Local Area network 3.

iLab 2: Office Network Expansion Connect to the iLab here. Submit your assignment to the Dropbox located on the silver tab at the top of this page. (See "Due Da

Question: a) Compare Bluetooth and WIFI based networks over the following factors: Data rate, Range, Application Focus, Battery Power, Frequency Band, Security. b) Differe

Router A router is used to route (transfer) data among two or more same networks. It verifies the next network point to which a data packet should be forwarded. The router is l


This ICT-related issue that has been raised in the contemporary media, and the article is required to be included as part of the essay: Undertake further research about this top