Design ia-32 instructions, Mechanical Engineering

1.  Given the data below, design IA-32 instructions to copy data in array X to array Y.  

.data

X   sdword   10,30,40,-10,-20,-4,-50

Y   sdword   7 dup (?)   

2.  Given the data below, design IA-32 instructions to copy each lower word in array X to array Y.  

.data

X   sdword   10,30,40,-10,-20,-4,-50

Y   sword      7 dup (?) 

 3.  Given the data below, design IA-32 instructions to find the greatest byte in array X and save it in Y.   

.data

X   sdword   10000, 15000, -20000

Y   sbyte       ?  

4.  Given the data below, design IA-32 instructions to rotate the characters in string in X to the right.  

.data

X   byte   "I love assembly language programming"

Posted Date: 3/6/2013 4:44:34 AM | Location : United States







Related Discussions:- Design ia-32 instructions, Assignment Help, Ask Question on Design ia-32 instructions, Get Answer, Expert's Help, Design ia-32 instructions Discussions

Write discussion on Design ia-32 instructions
Your posts are moderated
Related Questions
What is solar energy?


Determine the percentage savings in the material: A hollow shaft containing an inside diameter 0.5 times the outer diameter is to replace the solid shaft of the similar materi

Compare Two Stroke with four stroke Engine: T w o Stroke Engine In two stroke engine all the four operation that is suction, compression, ignition and exhaust are compl


Find out the power - hollow shaft: A hollow shaft of internal diameter 400 mm & external diameter 450 mm is needed to transmit power at 120 rpm. Find out the power it may tran

Carburettor Tuning :  It is very important that the carburettor is tuned properly to attain the best fuel efficiency and performance of the motorcycle. Since air screw is factory

Stress Strai n Curves (Tension): When a bar or specimen is subjected to a gradually increasing axial tensile load, the strains and stresses can be found out for number of loa

A Spring - mass system which is subjected to a harmonic force FCoswt. calculate the response of the system, refer figure Given x (0) = 0.01 m x(0) = 0.04 m/sec w = 30 rad/

Create Visual Basic function ffactor(Re, rr) that calculates the Darcy-Weisbach friction factor in a pipe or duct, where Re is the Reynolds No. and rr is the relative roughness, us