Define some characteristics of standing waves, Physics

(1) Standing pulse can be longitudinal / transverse.

(2) The disturbance confined to a particular part among the starting point and reflecting point of the ray.

(3) There is no forward speed of the disturbance from single molecule to the adjoining particle and so on, beyond this ceratin section.

(4) The total energy related with a stationary wave is twice the power of every of incident and reflected pulse. As in stationary pulse nodes are permanently at rest. So no power can be transmitted across then i.e. power of single part is confined in that section. Though this energy oscillates among kinetic energy and elastic potential energy of molecules of the medium.

 

Posted Date: 4/15/2013 3:42:45 AM | Location : United States







Related Discussions:- Define some characteristics of standing waves, Assignment Help, Ask Question on Define some characteristics of standing waves, Get Answer, Expert's Help, Define some characteristics of standing waves Discussions

Write discussion on Define some characteristics of standing waves
Your posts are moderated
Related Questions
Difference among sound and light waves: (i) For propagation of sound rays material phase is required but no material medium is needed for light waves. (ii)Sound rays are long


Example of an impure spectrum

Q. Find the shell temperature? In a shell-and-tube heat exchanger, one fluid passes through a central tube while another fluid flows through an outer shell in the opposite dire

Characteristics of a Transmitted Pulse The below animation depicts the boundary behavior of a pulse that is moving along a less dense incident and medium towards that is approa

to measure the extension of an experimental wire due to different pulling forces using searle''s apparatues.hence, determine the young modules of the material of the wire.

Electric Potential: Electric Potential verifies the flow of charge. Its unit is volt, represented as "v".

DC voltage measurements: Examples of how to make DC voltage measurements are show in the two diagrams below. In both cases, the red and black test leads are connected to the '

In the circuit shown below, a potentiometer is used to vary the current to the lamp. If the only resistance is due to the lamp, what is the current in the circuit?

Precaution to minimize Radiation Danger: 1. One should keep safe distance away from radiation emitting source. 2. The radiation from the reactor are shielded by thick concr